Instruction manual

Page 44 of 100 Report No. 255837
TRF No. IEC60335_2_40F
IEC 60335-2-40
Clause Requirement – Test Result Verdict
24.7
Hose-sets for connection of appliances to the water
mains, complying with IEC 61770 and supplied with
the appliance (IEC 60335-1/A1)
Not intended to be connected
to the water mains.
N/A
24.101
Replaceable parts of thermal control devices
identified by marking (IEC 60335-2-40)
Not considered. N/A
25 SUPPLY CONNECTION AND EXTERNAL FLEXIBLE CORDS
—
25.1
Appliance not intended for permanent connection to fixed wiring, means for
connection to the supply:
—
- supply cord fitted with a plug
1. Not checked in this test
report.
2. The manufacturer, service
agent or similarly qualified
person shall use a proper
cross sectional area of supply
cord referring to an installation
manual.
P
- an appliance inlet having at least the same degree
of protection against moisture as required for
appliance
N/A
- pins for insertion into socket-outlets
N/A
Supply cord fitted with plug provided, if (IEC 60335-2-40): —
- appliance only for indoor use (IEC 60335-2-40),
N/A
- marked with rating of 25 A or less and
(IEC 60335-2-40)
N/A
- complies with code requirements of country where
it will be used (IEC 60335-2-40).
N/A
Appliance inlet not allowed (IEC 60335-2-40)
N/A
25.2
Appliance not provided with more than one means of
connection to the supply mains
P
Stationary appliance for multiple supply may be
provided with more than one means of connection,
provided electric strength test of 1250 V for 1 min
between each means of connection causes no
breakdown
N/A
25.3
Connection of supply conductors for appliance
intended to be permanently connected to fixed wiring
possible after the appliance has been fixed to its
support
N/A
Appliance provided with a set of terminals for the
connection of cables or fixed wiring, cross-sectional
areas specified in 26.6
N/A
Appliance provided with a set of terminals allowing
the connection of a flexible cord
N/A