Instruction manual

Page 59 of 100 Report No. 255837
TRF No. IEC60335_2_40F
IEC 60335-2-40
Clause Requirement – Test Result Verdict
30.2.4
Base material of printed circuit boards subjected to
needle-flame test of annex E (IEC 60335-1/A2)
Tested in accordance with
Annex E.
P
Test not carried out by specified items .................... :
N/A
31 RESISTANCE TO RUSTING
—
Relevant ferrous parts adequately protected against
rusting
Adequately protected. P
Salt mist test of IEC 60068-2-52, severity 2
(IEC 60335-2-40)
P
Before test, coatings are scratched by means of a
harden steel pin as specified (IEC 60335-2-40)
P
Five scratches made at least 5 mm apart and at
least 5 mm from the edges (IEC 60335-2-40)
P
Appliance not deteriorated to such an extent that
compliance with clause 8 and 27 is impaired
(IEC 60335-2-40)
No deterioration. P
Coating not be broken and not loosened from the
metal surface (IEC 60335-2-40)
P
A
ANNEX A (INFORMATIVE)
ROUTINE TESTS
—
Description of routine tests to be carried out by the
manufacturer
N/A
B
ANNEX B (NORMATIVE)
APPLIANCES POWERED BY RECHARGEABLE BATTERIES
—
The following modifications to this standard are
applicable for appliances powered by batteries that
are recharged in the appliance
Not powered by rechargeable
batteries.
N/A
This annex does not apply to battery chargers
N/A
3.1.9 Appliance operated under the following conditions: —
- the appliance, supplied by its fully charged battery,
operated as specified in relevant part 2
N/A
- the battery is charged, the battery being initially
discharged to such an extent that the appliance
cannot operate
N/A
- if possible, the appliance is supplied from the
supply mains through its battery charger, the
battery being initially discharged to such an extent
that the appliance cannot operate. The appliance is
operated as specified in relevant part 2
N/A