Instruction manual

Page 60 of 100 Report No. 255837
TRF No. IEC60335_2_40F
IEC 60335-2-40
Clause Requirement – Test Result Verdict
If the appliance incorporates inductive coupling
between two parts that are detachable from each
other, the appliance is supplied from the supply
mains with the detachable part removed
N/A
3.6.2
Part to be removed in order to discard the battery is
not considered to be detachable
N/A
5.101
Appliances supplied from the supply mains tested as
specified for motor-operated appliances
N/A
7.1
Battery compartment for batteries intended to be
replaced by the user, marked with battery voltage
and polarity of the terminals
N/A
7.12
The instructions for appliances incorporating
batteries intended to be replaced by the user
includes required information
N/A
Details about how to remove batteries containing
materials hazardous to the environment given
N/A
7.15
Markings placed on the part of the appliance
connected to the supply mains
N/A
8.2
Appliances having batteries that according to the
instruction may be replaced by the user need only
have basic insulation between live parts and the
inner surface of the battery compartment
N/A
If the appliance can be operated without batteries,
double or reinforced insulation required
N/A
11.7 The battery is charged for the period described
N/A
19.1
Appliances subjected to tests of clause 19.101,
19.102 and 19.103
N/A
19.101
Appliances supplied at rated voltage for 168 h, the
battery being continually charged
N/A
19.102
Short-circuiting of the terminals of the battery, being
fully charged, for appliances having batteries that
can be removed without the aid of a tool
N/A
19.103
Appliances having batteries replaceable by the user
supplied at rated voltage under normal operation
with the battery removed or in any position allowed
by the construction
N/A
21.101
Appliances having pins for insertion into
socket-outlets have adequate mechanical strength,
checked according to procedure 2 of
IEC 60068-2-32
N/A
Part of the appliance incorporating the pins subjected to the free fall test, procedure 2,
of IEC 60068-2-32, the number of falls being:
—
- 100, the mass of part does not exceed 250 g
N/A
- 50, the mass of part exceeds 250 g
N/A