Instruction manual

Page 61 of 100 Report No. 255837
TRF No. IEC60335_2_40F
IEC 60335-2-40
Clause Requirement – Test Result Verdict
After the test, the requirements of 8.1, 15.1.1, 16.3
and clause 29 are met
N/A
22.3
Appliances having pins for insertion into
socket-outlets tested as fully assembled as possible
N/A
25.13
An additional lining or bushing not required for
interconnection cords operating at safety extra-low
voltage
N/A
30.2
For parts of the appliance connected to the supply
mains during the charging period, 30.2.3 applies
N/A
For other parts, 30.2.2 applies
N/A
C
ANNEX C (NORMATIVE)
AGEING TEST ON MOTORS
—
Tests, as described, carried out when doubt with
regard to the temperature classification of the
insulation of a motor winding
No doubt. N/A
E
ANNEX E (NORMATIVE)
NEEDLE-FLAME TEST
—
Needle-flame test carried out in accordance with IEC 60695-11-5, with the following
modifications (IEC 60335-1/A2):
—
5 Severities (IEC 60335-1/A2) —
Duration of application of test flame is 30 s ± 1 s
(IEC 60335-1/A2)
PCB P
9 Test procedure (IEC 60335-1/A2) —
9.1
Specimen so arranged that flame can be applied to a
vertical or horizontal edge as shown in examples of
figure 1 (IEC 60335-1/A2)
N/A
9.2 First paragraph does not apply (IEC 60335-1/A2)
N/A
If possible, flame is applied at least 10 mm from a
corner (IEC 60335-1/A2)
N/A
9.3 Test carried out on one specimen (IEC 60335-1/A2)
N/A
If specimen does not withstand test, test may be
repeated on two additional specimens, both
withstanding test (IEC 60335-1/A2)
N/A
11 Evaluation of test results (IEC 60335-1/A2) —
The duration of burning not exceeding 30 s
(IEC 60335-1/A2)
N/A
However, for printed circuit boards, the duration of
burning not exceeding 15 s (IEC 60335-1/A2)
P