User Manual

E-14
Selecting Heat Mode
You can select Heat mode if you want to heat your room.
You can adjust the temperature and the fan speed when heating.
1
Press the (On/Off) button.
Result
:  The operation indicator on the indoor unit lights up.
 The air conditioner starts up in the mode you selected last.
 The indoor unit beeps.
2
Press the button on the remote control until Heat is displayed.
Result
:  The indoor unit beeps each time you press the button.
 The air conditioner runs in Heat mode.
Note You can change modes at any time.
3
Press the button to adjust the temperature until the required
temperature is displayed.
You can set the temperature between 16°C and 30°C.
Result:
 Each time you press the button:
- The temperature adjusts by 1°C
- The indoor unit beeps
 If the room temperature reaches the set temperature
(selected temperature+5°C), the air conditioner stops
heating,but the fan is still operating.
 The air conditioner starts heating, provided that the room
temperature is lower than the desired temperature
(selected temperature+3°C).
4
Press the button to select the fan speed until the required setting is
displayed.
Auto  Low  Medium  High
Result
:  Each time you press the button, the indoor unit beeps.
 For the first 3~5 minutes, the fan may not operate to prevent
cool air from flowing out of the indoor unit.
This helps to warm the air in your room sufficiently.
5
To control the airflow direction, refer to page 20.
08'VIVACE_CIS_28587A_IB_E.indd 14 2007-12-18 11:07:04