User Manual (ver.2.0)
Table Of Contents
- Important Safety Instructions
- Precautions
- Before you start
- Chapter 1 : SETUP
- Chapter 2 : CONNECTIONS
- Choosing a Connection
- Connecting to a TV with an HDMI Jack (DVD-F1080 only)
- Connecting to a TV with a DVI Jack (DVD-F1080 only)
- Connecting to a TV (Progressive)
- Connecting to a TV (Interlace)
- Connecting to a TV (Video)
- Connecting to an Audio System (2 Channel Amplifier)
- Connecting to an Audio System (Dolby digital, MPEG2 or DTS Amplifier)
- Choosing a Connection
- Chapter 3 : BASIC FUNCTIONS
- Chapter 4 : ADVANCED FUNCTIONS
- Chapter 5 : NAVIGATING THE SETUP MENU
- Chapter 6 : REFERENCE
ENG-16
CONNECTIONS
1
Using Video/Audio cables, connect the VIDEO (yellow)/AUDIO
(red and white) OUT jacks on the rear of the DVD player to the
VIDEO (yellow)/AUDIO (red and white) IN jacks of your TV.
2
Turn on your DVD player and TV.
Note
- Noise may be generated if the audio cable placed too close to the power cable.
- If you want to connect to an Amplifier, please refer to the Amplifier connection page. (See pages 17 to 18)
- The number and position of the jacks may vary depending on your TV set. Please refer to the user's manual
of your TV.
- If there is one audio input terminal on the TV, connect it to the [AUDIO OUT][left] (white) jack of the DVD
player.
- If you press the VIDEO SEL. button when the DVD Player is in play mode, stop mode or no disc is inserted,
the Video Output mode changes in the following sequence: ( I-SCAN
➝ P-SCAN).
When HDMI is connected, these output modes will not appear.
RED
WHITE
YELLOW
RED
WHITE
YELLOW
Audio Cable
(Included)
Video Cable
(Included)
3
Press the input selector button on your TV remote control until
the Video signal from the DVD player appears on the TV
screen.
Connecting to a TV (Video)
F1080_FP580_XAA1(PV2) 11/12/07 1:13 PM Page 16