Samsung TV F/W Update Guide Model : 2007 models LCD TV : LNT series PDP TV : HPT series DLP TV : HLT series Samsung Electronics
1. Prepare the USB Memory Drive 1. Save the firmware file from Samsung.com onto your computer. 2. Connect the USB Memory Drive to the USB port of your PC. Copy the file onto the USB Memory Drive. 3. Go to the USB Memory Drive and then double click the file. 4. Press the “Unzip” button. 5. Unzipping is in progress. 6. After completing, please press the “OK” and “Close” buttons. 7. A folder containing the firmware files has been added to the USB memory drive.
2. Firmware Upgrade with the USB Memory Drive 1. Turn the TV on, and then insert the USB Memory Drive into the USB port on the rear or side AV panel of the TV. 2. Press the Menu button on the remote control. 3. Select Setup, and then press Enter or the arrow button (▶) on the remote control. 4. On the Setup Menu, select SW Upgrade, and then press Enter or the arrow button (▶) on the remote control. 5. The TV displays USB. Press Enter or the arrow button (▶) on the remote control.
2. Firmware Upgrade with the USB Memory Drive 6. The TV scans the USB Memory Drive. Note: This may take up to 30 seconds. 7. A message will appear asking if you want to perform the firmware update. Select “Yes” and then press the “Enter” button on the remote control. 8. The firmware update will start. This should take 30 sec. to 1 min. -. Do not disconnect the USB drive during this step. -. Do not unplug the power cable or turn the TV off. 9.
3. How to check Firmware Version 1. Press the Menu button on the remote control TV F/W Version : 1024 2. Go to Setup. On the Setup Menu, select Function Help. 3. Highlight the On option as shown above, and then press the Info button on the remote control. The firmware version appears at the bottom of the screen.
Firmware Upgrade Error Messages 1. If the USB Memory Drive was not inserted into USB port. 2. If there are no files on USB Memory Drive. 3. While update is in progress, please do not pull the USB Memory Drive out or do not unplug the power cable.