User Guide

25
ENG
FUNCTIONS
SOFTWARE UPDATE
+ Updating with USB
Samsung may offer updates for the Soundbar's
system firmware in the future.
If an update is offered, you can update the firmware
by connecting a USB device with the firmware
update stored on it to the USB port on your
Soundbar.
Note that if there are multiple update files, you must
load them onto the USB device singly and use them
to update the firmware one file at a time.
Please visit Samsung.com or contact the Samsung
call center to receive more information about
downloading updates files.
1. While the Soundbar is turned off, connect the
USB storage device that contains the updating
firmware to the Soundbar’s USB port.
2. Turn on the Soundbar UPDATE appears on the
display and updating begins within 3 minutes.
• Upon completion of updating, the Soundbar
turns off and on automatically.
If UPDATE was not displayed
1. Turn off the Soundbar, connect the USB storage
device that contains update files to the
Soundbar’s USB port.
2. Disconnect the power cord, reconnect it and turn
it on.
● Updating firmware may not work properly
if audio files supported by the Soundbar
are stored in the USB storage device.
● Do not disconnect the power or remove
the USB device while updates are being
applied. The main unit will turn off
automatically after completing the
firmware update.
● After reset, all settings are reset to their
factory default settings. We recommend
you write down your settings so that you
can easily reset them after the update.
Note that updating firmware resets
subwoofer connection too. If connection
to the subwoofer is not established
automatically after resetting,
refer to page 13.
If the firmware fails to update, we
recommend formatting the USB device in
FAT16 and trying again.
● Do not format the USB device in the NTFS
format. The Soundbar does not support
the NTFS file system.
● Depending on the manufacturer, some
USB devices may not be supported.
+ Auto update
Even when the Soundbar is turned off, the
Soundbar will automatically check latest software
version and continue to update if it was connected
to the Internet.
● The Soundbar is configured to run auto
update by default.
● To use auto update function, the
Soundbar must be connected to the
Internet.
● Wi-Fi connection to the Soundbar will be
terminated if its power cord was
disconnected or the power was cut off.
Turn on the Soundbar and reconnect.