User Manual 2021.05.27
Table Of Contents
- HW-LST70T_ENG
- 01 Checking the Components
- 02 Product Overview
- 03 Using the Remote Control
- 04 Connecting the Soundbar
- 05 Installing the Wall Mount
- 06 Using a wired connection to the TV
- 07 Using a wireless connection to the TV
- 08 Connecting an External Device
- 09 Connecting a Mobile Device
- 10 Connecting an Amazon product
- 11 Software Update
- 12 Troubleshooting
- 13 License
- 14 Open Source License Notice
- 15 Important Notes About Service
- 16 Specifications and Guide
- HW-LST70T_FRC
- 01 Vérification des composants
- 02 Présentation du produit
- 03 Utilisation de la télécommande
- 04 Connexion du Soundbar
- 05 Installation du support mural
- 06 Utilisation d'une connexion filaire avec le téléviseur
- 07 Utilisation d'une connexion sans fil avec le téléviseur
- 08 Connexion d'un appareil externe
- 09 Connexion d'un appareil mobile
- 10 Connecter un produit Amazon
- 11 Mise à jour logicielle
- 12 Dépannage
- 13 Licence
- 14 Avis de Licences Libres
- 15 Remarque Importante Concernant le Service
- 16 Caractéristiques et Guide
ENG - 12
03 USING THE REMOTE CONTROL
How to Use the Remote Control
Power
Turns the Soundbar on and off.
• Auto Power Down Function
The unit turns off automatically in the following
situations:
– In D.IN / Wi-Fi / BT mode if there is no audio
signal for 18 minutes.
D.IN
Press to enter the “D.IN” mode.
Source
Press to select a source connected to the Soundbar.
Mute
Press the (Mute) button to mute the sound.
Press it again to unmute the sound.
Sound
Control
When pressed, the setting items such as TREBLE, or
SYNC are displayed in sequence. The desired item
can be adjusted using the Up/Down buttons.
– To adjust the TREBLE volume, select Sound
Control → TREBLE, and then use the Up/Down
buttons to adjust the volume within a -6 to +6
range.
– Press and hold the (Sound Control) button
for about 5 seconds to adjust the sound for each
frequency band. 150Hz, 300Hz, 600Hz, 1.2kHz,
2.5kHz, 5kHz, and 10kHz are selectable using
the Left/Right buttons and each can be
adjusted to a setting between -6 to +6 using
the Up/Down buttons. (Make sure the Sound
mode is set to “STANDARD”.)
– If the video on the TV and audio from the
Soundbar are not synchronized, select SYNC in
Sound Control, and then set the audio delay
between 0~300 milliseconds by using the Up/
Down buttons.
– SYNC is only supported for some functions.