Installation guide

CHAPTER 2. MMC Programming OfficeServ 7400 Programming Guide
Samsung Business Communications 2-68
[300] CUSTOMER ON/OFF PER STATION
Allows the following features to be enabled/disabled on a per-station basis.
No Option Default Description
00 ACCESS DIAL ON Determines whether a user can select a trunk or trunk
group by dialling its directory number (DN). This selec-
tion should be turned off when using LCR.
01 MICROPHONE ON Allows phones to be used in speakerphone mode.
02 OFF-HOOK RING ON Will allow a short burst of ring tone to indicate another call.
03 SMDR PRINT ON When the station is set for no Trunk Line calls to and
from this station, the station will not print on SMDR.
This includes transferred calls or calls picked up from
hold or park.
04 TGR ADV.TONE ON When this feature is set to ON, a warning tone will be
heard each time LCR advances to the next route.
05 VMAA FORWARD ON This feature selects whether Trunk Line calls can be
forwarded to voice mail: ON, permits forward to voice
mail; OFF, no forward to voice mail.
07 NGT PASSCODE ON When ON, the steps verifying the ring plan passcode
will be added in Ring Plan change.
08 INTRCOM SMDR OFF When set to OFF, the station will not print intercom calls
on SMDR.
09 FWD DELAY USE OFF When ON, calls will overflow to the Forward No Answer
destination when the Forward No Answer timer expires
even when the Forward No Answer feature is not acti-
vated at the called party extension.
11 FORWARD OVRD OFF When set to ON and the station calls another station
which has forwarding set, the call will not forward.
12 RECL TO OPER OFF When set to ON, if the station transfers a call and the
destination doesn’t answer, the call will recall to the
operator instead of the station.
13 SLT LP OPEN OFF When ON, SLI port receives real disconnect signal in-
stead of busy or error tone. (VMAA or DATA ports al-
ways receive real disconnect signal.)
15 CID TO SLT OFF When a MIS module is installed and this option is set to
ON, the system will provide the CID signal to SLTs.
22 NO RCL FLASH OFF When the hook switch is flashed or the flash key is
pressed, a recall signal will not be sent to the system.