User Manual (ver.1.0)

English-16

Memorizing the Channels

Your TV can memorize and store all of the available channels for both “off-air” (antenna) and cable channels.

After the available channels are memorized, use the CH or CH buttons to scan through the channels.

This eliminates the need to change channels by entering the channel digits. There are three steps for memorizing channels:

selecting a broadcast source, memorizing the channels (automatic) and adding or deleting channels (channel manager).

Selecting the Video Signal-sour

Before your television can begin memorizing the available channels, you must specify the type of signal source that is connected to the

TV (i.e. an antenna or a cable system).

1. Press the MENU button to display the menu.

Press the  or  buttons to select “Channel”, then press the ENTER button.

2. Press the ENTER button select “Antenna”.

Press the  or  buttons to select “Air” or “Cable”, then press the ENTER button.

Press the EXIT button to exit.

Storing Channels in Memory (Automatic Method)

1. Press the MENU button to display the menu.

Press the  or  buttons to select “Channel”, then press the ENTER button.

2. Press the  or  buttons to select “Auto Program”, then press the ENTER button.

3. Press the  or  buttons to select the antenna connection, then press the

ENTER button.

Air: “Air” antenna signal. / Cable: “Cable” antenna signal. /

Air+Cable: “Air” and “Cable” antenna signals.

4. After all the available channels are stored, the “Auto Program” menu reappears.

Press the

EXIT button to exit.

Alternately, you can press the AUTO PROG. button on the remote control to bring up

the Auto Program menu.

BN68-00883V-00Eng.qxd 10/1/04 10:57 PM Page 16