User Manual
Table Of Contents
- Important safety instructions
- Introducing your new range
- Before you begin
- Surface cooking
- Operating the oven
- The oven control panel
- Setting the clock
- Setting the kitchen timer
- Timed cooking
- Delay Start
- Turning the oven light on and off
- Minimum and maximum settings
- Using the oven racks
- Baking
- Convection baking
- Convection roasting
- Broiling
- Using the easy cook feature
- Using the favorite cook feature
- Using the keep warm feature
- Using the sabbath feature
- Extra features
- Maintaining your appliance
- Troubleshooting
- Warranty (U.S.A)
- Warranty (CANADA)
- Consignes de sécurité importantes
- Présentation de votre nouvelle cuisinière
- Avant de commencer
- Table de cuisson
- Utilisation du four
- Tableau de commande du four
- Réglage de l'horloge
- Réglage de la minuterie
- Cuisson minutée
- Départ différé
- Activation et désactivation de l'éclairage du four
- Réglages minimum et maximum
- Utilisation des grilles du four
- Cuisson traditionnelle
- Cuisson par convection
- Rôtissage par convection
- Cuisson au gril
- Utilisation de la fonction Cuisson facile
- Utilisation de la fonction Cuisson favorite
- Utilisation de la fonction de maintien au chaud
- Utilisation de la fonction Shabbat
- Fonctions complémentaires
- Entretien de votre appareil
- Dépannage
- Garantie (États-Unis)
- Garantie (CANADA)
English 47
Troubleshooting
DRAWER
Problem Possible cause Solution
The drawer
does not slide
smoothly or
drags.
The drawer is out of
alignment.
Fully extend the drawer and
push it all the way in. See the
page 41.
The drawer is over-loaded or
the load is unbalanced.
Reduce weight. Redistribute
drawer contents.
Information codes
OVEN
Displayed
Code
Possible cause Solution
C-d0
This code occurs if the control
key is short for 1 minute.
Press OFF and restart the
oven. If the problem persists,
disconnect all power to the
range for at least 30 seconds
and then reconnect the power. If
this does not solve the problem,
call for service.
C-d1
This code occurs if the door lock
is mispositioned.
C-F0
This code occurs if
communication between
the Main and Sub PBA is
interrupted.
C-F2
This code occurs if
communication between the
Main and Touch is interrupted.
C-20
The oven sensor is open when
the oven is operating.
The oven sensor is short when
the oven is operating.
C-21
This code occurs if the internal
temperature rises abnormally
high.
C-30
The PCB sensor is open when
the oven is operating.
The PCB sensor is short when
the oven is operating.
C-31
This code occurs if the PCB
temperature rises abnormally
high.
Call for service
NE58K9430SS_AA_AC_DG68-00721A-06_EN+CFR.indb 47 2018-12-17 4:50:46