Installation Guide

installing the range
INSTALLING THE ANTI-TIP DEVICE
WARNING WARNING To reduce the risk of tipping, the appliance must be secured by properly
installing the Anti-Tip device packed with the appliance.
• Refer to the installation instructions supplied with the bracket.
• Unless properly installed, the range could be tipped by stepping or sitting on the door. Injury may
result from spilled hot liquids or from the range itself.
Anti-Tip
bracket
Screw must enter wood or
concrete
*approximately
21/32”(16.5mm)
*NOTE: To install Anti-Tip bracket,
release the leveling leg. A minimum
clearance of 21/32”(16.5mm) is required
between the range bottom and the
kitchen floor.
1. Locate the bracket using the template
The Anti-Tip bracket is packaged with a template. The instructions include information necessary to
complete the installation. Read and follow the instructions on the sheet (template) for range installation.
2. Level the range
Level the range by adjusting the leveling legs with a wrench.
Lower range
Raise range
Leveling leg
English - 11
03 INSTALLING THE RANGE
Manual Installation_30 Oven_SECA_DG68-00109F-08_EN+CFR.indb 11 9/6/2018 6:52:54 PM