User Manual

E-14
Cutting/Flaring the Pipes
1
Make sure that you prepared the required tools.
(pipe cutter, reamer, flaring tool and pipe holder)
2
If you want to shorten the pipe, cut it using a pipe cutter ensuring that the cut
edge remains at 90° with the side of the pipe. There are some
examples of correctly and incorrectly cut edges below.
Oblique Rough Burr
3
To prevent a gas leak, remove all burrs at the cut edge of the pipe using
a reamer.
4
Carry out flaring work using flaring tool as shown below.
Flaring tool
Clutch type Wing nut type
A
Die
Copper pipe
York
Die
Copper pipe
Flare nut
Outer diameter
(mm)
A(mm)
Flare tool for
R410A clutch type
Conventional flare tool
Clutch type Wing nut type
6.35
0~0.5 1.0~1.5 1.5~2.0
9.52
0~0.5 1.0~1.5 1.5~2.0
12.70
0~0.5 1.0~1.5 1.5~2.0
15.88
0~0.5 1.0~1.5 1.5~2.0
5
Check if you flared the pipe correctly. There are some examples of
incorrectly flared pipes below.
Inclined Damaged Surface Cracked Uneven Thickness
6
Align the pipes and tighten the flare nuts first manually and then with a torque
wrench, applying the following torque.
Outer diameter
(mm)
Connection
Torque(kgf•cm)
Flare dimension
(mm)
Flare shape
(mm)
6.35 145
~175 8.70~9.10
9.52 333
~407 12.80~13.20
12.70 505
~615 16.20~16.60
15.88 630
~769 19.30~19.70
R 0.4~0.8
90° ±2°
45°
±2°
In case of needing brazing, you must work with Nitrogen gas blowing.
CAUTION
AVXWV@@_IM_E_29819-1_4.14.09.indd 14 2009-4-14 10:15:39