Installation Guide

English 65
Maintenance
Surface burners
Burner controls
Make sure all surface burner knobs are in the OFF position.
1. Pull out the knobs from the control valve
stems as shown.
2. Clean the knobs in warm, soapy water.
Then, rinse and dry them thoroughly.
3. Clean the stainless steel surfaces using
stainless steel cleaner.
4. Reinsert the knobs into the control valve
stems.
CAUTION
• Do not clean the control knobs in a dish washer.
• Do not spray cleansers directly onto the control panel. Moisture entering the electric
circuits may cause electric shock or product damage.
Cooktop surface
The porcelain-enameled cooktop surface needs to be kept clean. It is advisable to remove
food spills immediately after they take place.
1. Turn off all surface burners.
2. Wait until all burner grates cool down, and
then remove them.
3. Clean the cooktop surface using a soft
cloth. If food spills run into gaps of the
burner components, remove the burner
cap and the head, and wipe out the spills.
4. When cleaning is nished, reinsert the
burner components, and put the burner
grates into position.
CAUTION
• Do not use a steel-wool pad or abrasive cleaner, which can scratch or damage the enamel
surface.
• Do not remove the cooktop surface to clean it. The gas lines leading to the burner
manifolds can be damaged, resulting in a re or system failure.
NX58J7750S�_AA_AC_DG68-00623A-02_EN.indd 65 2015-06-25 �� 10:16:08