Installation Guide

English 71
Maintenance
To re-install the oven door
1. Firmly grasp both sides of the door at the
top.
2. With the door set at the same angle as the
removal position (about 5 degrees from
vertical), slide the hinge arms into the
hinge slots at the bottom of the door.
3. Open the door fully. If you cannot open
the door fully, the hinge arms are not
properly in the hinge slots.
4. Lock the hinge arms by pushing them up
against the front frame of the oven.
5. Close the door, and make sure it opens and
closes normally.
Storage drawer
1. Slide open the drawer until it stops.
2. Locate the roller guide clips on either
side. Using both hands, pull down the left
clip while lifting the right clip, and then
remove the drawer.
3. Clean the drawer in warm, soapy water
using a cloth or soft brush. Then, rinse and
dry it thoroughly.
4. Put the drawer in the roller guides on
either side, and then snap the clips into
place.
NX58J7750S�_AA_AC_DG68-00623A-02_EN.indd 71 2015-06-25 �� 10:16:13