Installation Guide
English 29
Installation instructions
Memo
To adjust ame low setting
Identify which burner is exhibiting too high or too low of simmer rate via manifold
panel graphics.
Simmer Set Screw
1. Rotate a knob to "LO" position and
remove the knob from the valve shaft
while the ame is lit.
2. Carefully push the screw driver into
the C chanel of the valve, until it hits
the simmer set screw. Make sure the
screwdriver athead is seated into the
set screw groove.
3. Rotate valve set screw clockwise to
decrease "LO" setting ame output, or
rotate set screw counter clockwise to
increase "LO" setting ame output.
NX5000M_NX58M6650WS_AA_DG68-00992A-01_EN+MES+CFR.indb 29 2017-08-16 2:38:36