User manual

121
Screen Adjustment
4
4 Screen Adjustment
1 Press the button to select Zoom/Position.
2 Select the Zoom or Position.
3 Press the [ ] button.
4 Press the /// button to move the picture.
5 Press the [ ] button.
6 Select Close by pressing the and buttons sequentially.
If you want to reset the picture to its original position, select Reset in the Zoom/Position screen.
The picture will be set to its default position.
4.3.3 4:3 Screen Size
Available only when picture size is set to Auto Wide.
You can determine the desired picture size at the 4:3 WSS (Wide Screen Service) size or the original size.
Each European country requires different picture size.
Not available in PC, Component or HDMI mode.
4.3.4 PC Screen Adjustment
Coarse / Fine: Removes or reduces picture noise. If the noise is not removed by Fine-tuning alone, use
the Coarse function to adjust the frequency as best as possible (Coarse) and Fine-tune again. After the
noise has been reduced, re-adjust the picture so that it is aligned with the centre of screen.
Position: To adjust the PC’s screen position if it is not centred or does not fit the product screen. Press
the or button to adjust the Vertical Position. Press the or button to adjust the Horizontal
Position.
Image Reset: Resets the image to the default settings.
This option is available when the input source is PC.
4.3.5 Resolution Select
If the picture is not normal even when the resolution of the graphics card is one of the following, you can
optimize the picture quality by selecting the same resolution for the product as the PC using this menu.
Available resolutions: Off / 1024 x 768 / 1280 x 768 / 1360 x 768 / 1366 x 768
This option is available when the input source is PC.