User Manual

overview
10_ overview
AT A GLANCE
Front of the main unit
a
b
Item Description
a
Power indicators POWER
ON : While the power is on
OFF : If the power is off
b
Status Indicators for Lens
Module
The LED turns on when each channel video is successfully displayed.
Side of the main unit
a b c e fd
g
h
Item Description
a
Connection terminal of lens
module
This terminal is connected to the lens module through the cable to connect the lens
module.
b
HDMI port By connecting an HDMI cable, you can watch a live feed on the monitor.
c
Audio terminal
AUDIO IN Used to connect to a microphone.
AUDIO OUT Used to connect to speakers.
d
Alarm I/O Port
ALARM IN
Used to connect alarm input signals. Up to two ports can be used.
Refer to “Alarm In Wiring Diagram” (page 18).
ALARM OUT
Used to connect alarm output signals. Up to two ports can be used.
Refer to “Alarm Out Wiring Diagram” (page 19).
GND Ground terminal.
e
Power supply terminal
Terminal used to connect to the DC12V power adaptor.
f
PoE+ port
A port that connects to the PoE injector and network cable for power and network connection.
g
Reset Button
The button restores all camera settings to the factory default.
Press and hold for about 5 seconds to reboot the system.
J
If you reset the camera, the network settings will be adjusted so that DHCP can be
enabled. If there is no DHCP server in the network, you must run the Device Manager
program to change the basic network settings such as IP address, Subnet mask,
Gateway, etc., before you can connect to the network.
h
Micro SD Card slot Compartment for the Micro SD card.