User Manual
Table Of Contents
- overview
- installation & connection
- network connection and setup
- Connecting the Camera Directly to Local Area Networking
- Connecting the Camera Directly to a DHCP Based DSL/Cable Modem
- Using Device Manager
- Automatically searching camera
- Configuring IP address
- Manually registering camera
- Automatically configuring IP
- Port Range Forward (Port Mapping) Setup
- Connecting to the Camera from a Shared Local PC
- Connecting to the Camera from a Remote PC via the Internet
- web viewer
- appendix
12_ installation & connection
installation & connection
INSTALLATION
Precautions before installation
Ensure you read out the following instructions before installing the camera:
~
Organize the cable separately in order to prevent excessive burden on the lens module while the camera is
installed (within 1m from the lens module ).
~
Select an installation site that can hold at least 5 times the camera’s weight.
~
Stuck-in or peeled-off cables can cause damage to the product or a fire.
~
For safety purposes, keep anyone else away from the installation site.
And put aside personal belongings from the site, just in case.
~
The power must be turned off when installing or removing lens module.
Installing the main unit
1. Before mounting the main unit to the ceiling or wall, the installation bracket must be joined to the main unit
first.
Installation bracket
2. Use four screws provided to join the installation bracket to the main unit.
3. Use installation screws provided to install the main unit together with the installation bracket to the wall.