User Manual
Table Of Contents
- overview
- installation & connection
- network connection and setup
- Connecting the Camera Directly to Local Area Networking
- Connecting the Camera Directly to a DHCP Based DSL/Cable Modem
- Using Device Manager
- Automatically searching camera
- Configuring IP address
- Manually registering camera
- Automatically configuring IP
- Port Range Forward (Port Mapping) Setup
- Connecting to the Camera from a Shared Local PC
- Connecting to the Camera from a Remote PC via the Internet
- web viewer
- appendix
installation & connection
14_ installation & connection
Install lens module (SLA-T2480VA/SLA-T4680VA)
1.
Make a hole for the lens module at the spot where you want to install it.
2. Remove the protective film to use the double-sided tape of the lens module bracket
and attach it to match the hole.
J
`
Remove foreign substances on the target object before attachment.
3. Insert the lens module into the lens module bracket.
4. Tighten the screws in the screw hole on the bracket.
`
This only applies to the SLA-T2480VA.
5. Organize the cable separately (within 1m from the lens module).
Installing the lens module in the main unit
Connect the lens module cable to the [CAMERA] port on the side of the main unit.
J
`
Connect the lens module and turn it on.
`
Turn off the main unit power when connect or remove lens module
`
Install the lens at least 3 meters away from the main unit. It is recommended to not fix the cable within 3 meters from the
main unit.
`
It is recommended to wrap the ferrite core two times around the power cable and LAN cable.
<SLA-T1080FA>
<SLA-T2480VA/SLA-T4680VA>
<SLA-T2480A/SLA-T4680A>
3m
PoE+ Router