User Manual

English _17
! INSTALLATION & CONNECTION
CONNECTING WITH OTHER DEVICE
HDMI Supported Monitor
PoE+ or DC 12V power connection
Powering and networking
Connect the POE+ device with the POE+ port of the Main Unit.
internet
J
`
Connect and use a POE+ -enabled router.
`
Use a POE+ device that complies with the IEEE 802.3at standard.
`
If you connect using an PoE+ -enabled router, you don’t need a separate power supply cable to power it on.
Network Cable Specification
Item Contents Remark
Connector RJ45 (10/100/1000BASE-T)
Ethernet 10/100/1000Base-T
To operate with 1000BASE-T, a cable of
Category 6 or higher should be used for
the Giga hub.
Cable Category 6
Max Distance 100 m DC Resistance ≤ 0.125 Ω/m
PoE+ Support IEEE 802.3at
Power Supply
Use the screwdriver to connect each line (+, –) of the power cable to the corresponding power port of the
camera.
J
`
If the power sources for PoE+ and DC 12 V are simultaneously turned on, the device power will be supplied by both of PoE+
and DC 12V.
-
You can also use a router featuring PoE+ to supply power to the camera.
-
Use PoE+ that is compliant with the IEEE 802.3at protocols.
`
Be careful not to reverse the polarity when you connect the power cable.
`
If you want to connect an external device, you must turn off the external device before proceeding.
`
Connect the set and the adapter power line first, and then connect the power cable to the outlet on the wall.
Power Cable Specification for Each Model
In case of DC 12V Input:
Wire Type (AWG) #18 #16 #14
Cable Length (Max.) 13 m 21 m 30 m