Quick Guide

ManualsBrandsSamsung ManualsTVPS50C450B1W

English -4

¦¦ Connecting¦a¦AV¦device

HD¦connection

DVD / Blu-ray player

/ HD Cable Box / HD

STB (Set-Top-Box)

satellite receiver

Using an HDMI Cable

HDMI OUT

VCR / DVD

Using a Scart Cable

EXT

RRG

HD¦connection

DVD /

Blu-ray player

Using an HDMI to DVI Cable

DVI OUT

AUDIO OUT

Component connection

DVD, Blu-ray

player, cable

box, STB satellite

receiver, VCR

Using a Component Cable

AUDIO OUTCOMPONENT OUT

VCR

AUDIO OUTVIDEO OUT

Using an Audio/Video Cable

RRG

[QSG]BN68-02789A-01Eng.indd 1 2010-03-09 오후 4:55:51

Summary of content (4 pages)

PAGE 1
¦¦ Connecting a AV device HD connection Using an HDMI Cable HDMI OUT DVD / Blu-ray player / HD Cable Box / HD STB (Set-Top-Box) satellite receiver HD connection Using an HDMI to DVI Cable DVI OUT DVD / Blu-ray player R AUDIO OUT Y Y W AUDIO OUT VCR W W VIDEO OUT R R Using an Audio/Video Cable R R B W W R R B G G Component connection EXT Using a Component Cable VCR / DVD Using a Scart Cable R B R R B G W W R R W AUDIO OUT W R Y Y COMPONENT OUT DVD, Blu-ray pl
PAGE 2
Plasma TV QUICK SETUP GUIDE ¦¦ The Supplied Accessories yy Remote Control & Batteries (AAA x 2) yy Cleaning Cloth yy Owner’s Instructions yy Warranty Card / Safety Guide (Not available in some locations) yy Power Cord yy Blanking Bracket yy Ferrite Core (3EA) (depending on the country) See separate guide for installing the stand. (M4 X L16) yy Stand (1EA) yy Guide Stand (1EA) yy Screws (10EA) ✎✎Ferrite Core: The ferrite cores are used to shield the cables from interference.
PAGE 3
¦¦ Installing the Stand Preset Step 1 Step 2 s s s s s Front s Front s s Back Back SOURCE ✎✎Preset: Place the Guide Stand and Cover Neck onto the stand and fasten it using the screws. Applicable to models (Depending on the model) Step 1. Attach your PDP TV to the stand. ✎✎ Two or more people should carry the TV. ✎✎ Make sure to distinguish between the front and back of the stand when assembling them.
PAGE 4
¦¦ Plug & Play When the TV is initially powered on, basic settings proceed automatically and subsequently. If you want to reset this feature, press the MENU button to display menu. You can set the Plug & Play by selecting ‘Setup → Plug & Play’. VHF/UHF Antenna Cable or ANT OUT Power Input On the screen, you can set as follows. ✎✎The each step may vary depending on the Antenna source. Step 1 Step 2 Plug & Play Plug & Play Select the OSD Language. Plug & Play Select Select the usage mode.