User Manual

46
ENG
Confirming the Port
◆ The Multiple Display Control uses only “COM1”. This
control operates with neither “COM2” nor another port.
◆ To check which port is installed, enter “Control Panel ➜
System ➜ Device Manager ➜ Ports”.
◆ If another port is installed except the “COM1” port, you can
change to “COM1” from the “Device Manager” if you’re
using Windows 2000 or XP (please refer to the following
chapter). For all other operating systems, the change may be
made from your PC BIOS Setup.
◆ Use the Exit menu to end the program. The Help menu
shows how to use the program and general information
about the program.
Changing the Port
◆ The Multiple Display Control uses only “COM1”. This control operates with neither “COM2” nor
another port.
◆ You can change the port to “COM1” in Windows 2000 or XP. For all other operating systems, the
change may be made from your PC BIOS Setup.
◆ Enter “Control Panel ➜ System ➜ Device Manager ➜ Ports”. And then click the right of mouse to
enter “Properties
➜ Port Settings Tab ➜ Advanced”.
◆ Select “COM1”.
Click the right of mouse!
Select
COM1!