DJ68-40014A(영어) 2004.1.
DJ68-40014A(영어) 2004.1.29 9:12 AM 페이지2 IMPORTANT SAFEGUARDS ▶ This appliance must be connected to the same main voltage as shown on the rating plate. ▶ This vacuum cleaner is not suitable for removing liquids of any kinds. ▶ Carpets treated with a liquid cleaner must be allowed to dry before being cleaned with the unit. ▶ Never operate the vacuum cleaner without a dust bag. ▶ If a dust bag is not inserted, the cover cannot be closed, please do not close forcibly.
DJ68-40014A(영어) 2004.1.29 9:12 AM 페이지3 IDENTIFICATIONS PARTS HANDLE SUCTION HOSE AIR REGULATOR RUG/FLOOR SELECTOR DUST-FULL INDICATOR* TUBE * ON/OFF BUTTON POWER CONTROL SWITCH* BUTTON FOR SUCTION HOSE REMOVAL CARRYING HANDLE FLOOR NOZZLE CORD REWIND BUTTON ▶ Features marked with * may vary according to model. ASSEMBLING THE VACUUM-CLEANER READY FOR USE 1) Connect the suction hose to the suction tube. 2) Connect the suction tubes together 3) Connect the nozzle to the suction tube.
DJ68-40014A(영어) 2004.1.29 9:12 AM 페이지4 POWER CORD 1) PULLING OUT The power cord is long enough to be drawn out for convenience. 2) REWINDING Upon finishing cleaning disconnect the plug from the electrical outlet and just press the cord rewind button lightly with your toe. NOTE : When removing the power cord from the electrical outlet, grasp the plug, not the cord.
DJ68-40014A(영어) 2004.1.29 9:12 AM 페이지5 DUST-FULL INDICATOR If the“Dust-Full”indicator switch changes to“RED”while you are cleaning, the dust bag requires replacement. NOTE : If the“Dust-Full indicator continues to display“RED”even after changing the dust bag turn the cleaner off and check whether the hose, tube or nozzle is clogged. RUG/FLOOR SELETOR Before use make sure that the position of button is in right position for the type of surface to be cleaned. ② ① Push the side ① when cleaning the capets.
DJ68-40014A(영어) 2004.1.29 9:12 AM 페이지6 PARK POSITION Located on the top rear side of the vacuum cleaner, there is a support for a convenient park position during pauses when using the nozzle. TRANSPORTING AND STORING THE VACUUM CLEANER For easy storage and transportation, this vacuum cleaner has a clip system built on the body, which will keep the tube, hose and nozzle in a vertical position.
DJ68-40014A(영어) 2004.1.29 9:12 AM 페이지7 3) After removing the used dust bag, insert the cardboard bag collar of the new dust bag into the suction inlet to the full. 4) Press the dust cover down gently until the clamper relocks. FOR CLOTH FILTER BAG Use only a designated cloth filter bag: After using, if the cloth filter bag is full of dust, clean the cloth filter bag and use it again. TROUBLE SHOOTING PROBLEM CAUSE REMEDY Motor does not start No voltage Check cable, plug and socket.
DJ68-40014A(영어) 2004.1.29 9:12 AM 페이지8 This Vacuum cleaner is approved the following EMC Directive : 89/336/EEC, 92/31EEC and 93/68/EEC EN 61000-3-2 : 1995, EN 55014 : 1993 and EN 55104 : 1995 Low Voltage Safety Directive : 73/23/EEC and 93/68/EEC IEC 335-1, IEC 335-2-2, EN 60335-1 and EN 60335-2-2 DJ68-40014A REV(0.