Unit installation

35
ENGLISH
Number of
press
Display contents
Display
Units
Segment 1 Segment 2 Segment 3 Segment 4
12
Total indoor heat
exchanger capacity
C Two digits One digit First decimal kW
13 Protection control D
0 : air
conditioning
1 : heating
Protection
control
0 : no protection
control
1 : freezing
2 : non-stop
defrosting
3 : over-load
4 : discharge
Frequency state
0 : Normal
1 : Hold
2 : Down
3 : Up_limit
4 : Down_limit
-
14
Temperature of Heatsink
at PBA
E Two digit One digit First decimal °C
15
The Quantity of
connected Indoor Unit
F Three digits Two digits One digit set
long-1 Main Micom version Year(Hex) Month(Hex) Day(two digit) Day(One digit) -
long-1and 1 Inverter Micom version Year(Hex) Month(Hex) Day(two digit) Day(One digit) -
long-1and 2 EEPROM version Year(Hex) Month(Hex) Day(two digit) Day(One digit) -
5. DIP Switching setting
KEY ON (default) OFF Remark
K5
Auto Address
(Outdoor unit recognize the address or indoor
unit by random access.)
Manual Address
(Outdoor unit recognize the address of indoor
unit by rotary switch of indoor unit.)
In Monobloc K5
must be'ON'
K6 Operating time of base heater is 15min. Operating time of base heater is 20min.
Base heater will
operate under 0°C
K7 Anti-stack snow mode ON Anti-stack snow mode OFF
K8 Enable base heater Disable base heater
K9
Silence operation K9 K10 Mode
ON ON Disable silence mode
K10
ON OFF Silence mode Step.1
OFF ON Silence mode Step.2
OFF OFF Silence mode Step.3
K11 X Not defined
K12 X Not defined
K13
Whole current control K13 K14 Mode
ON ON Limit total current: 1_Down
K14
ON OFF Limit total current: 1_Down_OP1
OFF ON Limit total current: 1_Down_OP2
OFF OFF Limit total current: 1_Down_OP3
K15 X Not defined
K16 X Not defined
EHS mono_RC＊＊＊MHXGA_IM_E_34411A(2).indd 35 2012-03-08 오후 3:36:20