User Manual
04_ safety information
WARNING
CRITICAL
TRANSPORTATION AND
SITE WARNINGS
• When transporting and
installing the appliance,
care should be taken to
ensure that no parts of
the refrigerant circuit are
damaged.
• R-600a or R-134a is used as
a refrigerant.
Check the compressor label
on the rear of the appliance
or the rating label inside the
refrigerator to see which
refrigerant is used in your
refrigerator.
WARNING
CRITICAL INSTALLATION
WARNINGS
• Do not install this
appliance near a heater
or flammable material.
• Do not spray flammable gas
near the refrigerator.
- There is a risk of explosion or
fire.
• Do not install this appliance
in a humid, oily or dusty
location, or in a location
exposed to direct sunlight or
water (rain drops).
- Exposure can cause
insulation to deteriorate.
Deteriorated insulation on
electrical parts may cause
electric shock or fire.
• Do not place this refrigerator
in direct sunlight or expose to
the heat from stoves, room
heaters, or other appliances.
• Do not plug several
appliances into the same
multiple power board.
The refrigerator should
always be plugged into its
own individual electrical
outlet which has a voltage
rating that matches the
voltage on the rating plate.
- This provides the best
performance and also
prevents overloading house
wiring circuits, which could
cause a fire hazard from
overheated wires.
• If the wall socket is loose, do
not insert the power plug.
- There is a risk of electric
shock or fire.
• Do not use a cord that
shows cracks or abrasion
damage along its length or at
either end.
DA68-02935A-10.indb 4 2018. 7. 9. �� 4:53
safety information _05
• Do not bend the power cord
excessively or place heavy
articles on it.
• Do not use aerosols near the
refrigerator.
- Aerosols used near the
refrigerator may cause an
explosion or fire.
• Do not install this appliance
in a location where gas may
leak.
- This may result in an electric
shock or fire.
• We strongly
recommend you use
a qualified technician
or service company to
install or service the
refrigerator.
- Failing to do so may result
in an electric shock, fire,
explosion, problems with the
product, or injury.
• This refrigerator must be
properly installed and located
in accordance with the
manual before it is used.
• Connect the power plug in
the proper position with the
cord hanging down.
- If you connect the power
plug upside down, the wire
can get cut off and a cause
fire or an electric shock.
• Make sure that the power
plug is not squashed or
damaged by the back of the
refrigerator.
• When moving the refrigerator,
be careful not to roll over or
damage the power cord.
- This constitutes a fire hazard.
• The appliance must be
positioned so that the plug is
accessible after installation.
• The refrigerator must be
safely grounded.
- Always make sure that
you have grounded the
refrigerator before attempting
to investigate or repair any
part of the appliance.
Power leakages can cause
severe electric shock.
• Never use gas pipes,
telephone lines, or other
potential lightning attractors
as an electrical ground.
- Improper use of the
grounding plug can result
in a risk of electric shock.
If it is necessary to use an
extension cord, use only a
3-wire extension cord that
has a 3-blade grounding plug
and a 3-slot receptacle that
DA68-02935A-10.indb 5 2018. 7. 9. �� 4:53
DA68-02935A-11.indd 5 2020-10-16 3:02:03