Security Datasheet

SAMSUNG SDI Co., Ltd.
Date: January 1st, 2017 Revision no.: 00
MODEL: INR18650-35E
Page 5 of 11
or in worst case scenario irreversible damage and possible eye burns. Skin contact may lead to irritation and
possible skin burns.
CHRONIC: Skin contact may aggravate/exacerbate existing skin conditions, such as dermatitis. Chronic inhalation
may lead to the same symptoms as listed for acute inhalation above.
Indication of any immediate medical attention and special treatment needed
ADVICE TO DOCTOR: Treat symptomatically if the person comes into contact with the corrosive electrolyte liquid
contents of a damaged battery.
5. Fire Fighting Measures
Suitable extinguishing media
Cold water and dry powder in large amount are applicable.
Use metal fire extinction powder or dry sand if only few cells are involved.
Special hazards arising from the chemical
May form hydrofluoric acid if electrolyte comes into contact with water.
In case of fire, the formation of the following flue gases cannot be excluded:
Hydrogen fluoride (HF), Carbon monoxide and carbon dioxide.
Protective equipment and precautions for firefighters
Wear self-contained breathing apparatus and protective suit.
Additional information
If possible, remove cell(s) from fire fighting area. If heated above 125°C, cell(s) can explode/vent. Cell is
not flammable but internal organic material will burn if the cell is incinerated.
6. Accidental Release Measures
Personal precautions, protective equipment and emergency procedures:
As an immediate precautionary measure, isolate spill or leak area for at least 25 meters (75 feet) in all directions.
Keep unauthorized personnel away. Stay upwind. Keep out of low areas. Ventilate closed areas before entering.
Wear adequate personal protective equipment as indicated in Section 8.
Environmental precautions
Absorb spilled material with non-reactive absorbent such as vermiculite, clay or earth. Prevent from migration into
soil, sewers and natural waterways – inform local authorities if this occurs.
Methods and material for containment and cleaning up
Evacuate spill area immediately and remove sources of ignition. Do NOT touch spilled material. Cleanup
personnel must be trained in the safe handling of this product. Spills may be absorbed on non-reactive absorbents
such as vermiculite. Place cells or batteries into individual plastic bags and then place into appropriate containers
and close tightly for disposal. Ensure that cleanup procedures do not expose spilled material to any moisture.
Immediately transport closed containers outside. Lined steel drums are suitable for storage of damaged cells or
batteries until proper disposal can be arranged.
7. Handling and Storage
Precaution for Handling
Avoid short circuiting the cell. Avoid mechanical damage of the cell. Do not open or disassemble.