Manual

Troubleshooting
ENGLISH I
+ If you run into any problem using the camcorder, use the following table to troubleshoot
the problem.
+ If these instructions do not allow you to solve the problem, take a note of:
• The model and serial number marked on the bottom of the camcorder.
• Your warranty, if applicable.
÷ Then contact your nearest authorized service centen
Youcannot switch the • Check the battery pack (see page 22)
camcorder on. or the AC power adaptor, (see page 21)
Start/Stop does not * Check the POWER and LOCK/STANDBY
operate while shooting switches, set to CAMERAand STANDBY.
• You have reached the end of the cassette.
• Check the record protection tab on the cassette, (see page 25)
The carncorder goes • You have left the camcorder set to STANDBY
off automatically, for more than 5 minutes without using it, (see page 7)
• The battery pack isfully exhausted, (see page 24)
The battery pack is • The atmospheric temperature is too low, (see page 24)
quickly exhausted. • The battery pack has not been charged fully. (see page 23)
• The battery pack is completely dead, and cannot
be recharged. Use another battery pack.
You cannot eject the • The battery pack is exhausted fully,
cassette from the • A mechanical fault may have occurred. (see page 50)
compartment,
The DATE_IME indicator
flashesmore than 2 times • The lithium battery is not installed or exhausted
when you setthe fully. (see page 20)
camcorderto CAMERA,
The playback picture • The video heads may be dirty. (see page 48)
is of poor quality,
You can de nothing • A mechanical fault may have occured. (see page 50)
with the camcorder,
A