Service manual

Samsung Electronics 4-1

4. Disassembly and Reassembly

4-1 General Precautions on Disassembly

When you disassemble and reassemble components, you must use extreme caution. The close proximity of cables

to moving parts makes proper routing a must. If components are removed or replaced, any cables

disturbed by the procedure must be replaced as close as possible to their original positions. Before removing any

component from the machine, note the cable routing that will be affected.

Whenever servicing the machine, you must perform as follows:

1. Check to verify that documents are not stored in memory.

2. Move the printer cartridge to far right to cap the nozzle.

3. Unplug the power cord.

4. Use a flat and clean surface.

5. Replace only with authorized components.

6. Do not force plastic-material components.

7. Make sure all components are in their proper position.

1. Lift the control panel using hand.

2. Push the bushing on both ends of the roller slight-

ly inward, then rotate it until it reaches the slot as

shown below. Then lift the roller out.

Note : Check the roller for any dirt. If dirty, wipe it

off with soft cloth dampened with water. If

the roller is heavily worn, replace it with a

new one.

4-2 White Roller Ass’y

Bushing

White roller

Control panel