Service manual

Samsung Electronics 8-5

8-1-5-2 SYSTEM DATA

MODEM SPEED

Default = 14400 bps

Select baud rate of 14400, 12000, 9600, 7200, 4800, or

2400 bps. The lower the baud rate, the larger the

acceptable error rate. T30 protocol has a fixed speed

of 300 bps in the protocol mode. When the TX speed

is set to 14400 or 12000 bps, the RX speed will be

either V.17 or V.33. When the TX speed is set to 9600

or 7200 bps, the RX speed will be either V.29 or V.27

ter. When the TX speed is set to 4800 or 2400 bps, the

RX speed will be V.27 ter.

FAX TX LEVEL

Default = –12 dBm

FCC requires that the transmission level be less than

–9 dBm. From –9 dBm to –15 dBm is acceptable. You

can set the transmission level between 0 and –15

dBm in 1dBm steps using the control panel keypad.

Accuracy is +0/–3 dBm.

FAX RX LEVEL

Default = –43 dBm

Reception level may be too low due to cable losses. If

set to –43 dBm, reception sensitivity will be betWeen

0 and –43 dBm.

FLASH TIME

Default = 100 mseconds

Choose flash time 100/280/600 milliseconds.

PAUSE TIME

Default = 4.0 seconds

This sets the length of the pause time from 1 through

9 seconds, when the pause button is pressed.

8-1-5-3 CHANGING SYSTEM DATA

Press MENU and one-touch button 01 system data.

Then press 1 to choose ‘Tech’. Press

▲

▼

repeatedly to select the desired system data.

When the desired system data appears, enter the cor-

responding information to change the status of the

selected function. Press STOP to return to the date

and time display.