Installation manual

Fixing the Outdoor Unit in Position

OMPLETING THE

NSTALLATION

E-14

Checking and Testing Operations

The outdoor unit must be installed on a rigid and stable base to

avoid any increase in the noise level and vibration, particularly if the

outdoor unit is to be installed close to a neighbour.

If it is to be installed in a location exposed to strong winds or at a height,

the unit must be fixed to an appropriate support (wall or ground).

1 Position the outdoor unit so that the air flow is directed towards the

outside, as indicated by the arrows on the top of the unit.

2 Attach the outdoor unit to the appropriate support using anchor bolts.

3 If the outdoor unit is exposed to strong winds, install shield plates around

the outdoor unit, so that the fan can operate correctly.

➢

Certainly fix up its rubber leg, in order to prevent its vibration and

noise.

556 mm

Rubber leg

295 mm

To complete the installation, perform the following checks and tests to

ensure that the air conditioner is operating correctly.

1 Review all the following elements in the installation:

◆ Installation site strength

◆ Piping connection tightness to detect any gas leakages

◆ Connection wiring

◆ Heat-resistant insulation of the piping

◆ Drainage

◆ Earthing wire connection

◆ Correct operations (follow the steps below)

2 Press the button.

Result

: ◆ The indicator lights on the indoor unit flash at half-second

intervals.

◆ While the indoor unit opens, the indoor unit fan runs to start.

3 Press the button.

Result

: The outdoor unit operates in cooling or heating mode as

following the room temperature.

4 Air flow direction Press the button and check that the air flow

blades work properly.