User`s manual

INITIALIZING THE SVMi-8E/SVMi-16E

Perform a proper SVMi-8E/SVMi-16E system shut down. (Steps for performing a proper shut down are described

in the section Correct System Shutdown.)

Once the SVMi-8E/SVMi-16E is down and at a C:> DOS prompt, Press the red RST button to read the MMC data

and initialize SVMi-8E/SVMi-16E accordingly.

NOTE: After the SVMi-8E/SVMi-16E restarts you should change the value of MMC 740 so that it indicates "down-

load = No." This will prevent the system from overwriting any future changes you make to the SVMi-8E/SVMi-16E

database.

TESTING THE HARDWARE

1. Call each SVMi-8E/SVMi-16E port individually and confirm that SVMi-8E/SVMi-16E answers.

2. Call station group 509/ 5009, 529/5029, or 549/5049 and confirm that SVMi-8E/SVMi-16E answers.

If steps 1 and 2 above proved to be successful you have completed the installation and setup of the SVMi-

8E/SVMi-16E hardware.

You are now ready to begin programming the SVMi-8E/SVMi-16E Voice Mail/Auto Attendant system param-

eters. S

ee the SAMSUNG SVM

i-8E/SVMi-16E Programming Section.

Correct System Shutdown

Whenever possible one of the following procedures should be followed when shutting down the SVMi-8E/SVMi-

16E system and/or prior to shutting down the Telephone equipment.

PROCEDURE ONE

From the Main Status Screen (showing activity and port status):

1. Press 'Escape' and enter System Administration password (Default = 0000)

2. Select 'Operating Utilities'

3. Select 'Exit the SVMi-8E/SVMi-16E'

4. Enter System Administrator's password (Default = 0000)

The SVMi-8E/SVMi-16E will now shut down.When the system shows a DOS command line you may power off the

system and unplug the SVMi-8E/SVMi-16E card.

PROCEDURE TWO

1. From any phone on the system call one of the SVMi-8E/SVMi-16E ports or call the station group 509/5009.

529/5029, or 549/5049.

2. If the SVMi-8E/SVMi-16E answers with "please enter your password" press [*] to escape to the main menu.

3. From the main menu press [#][0000]

4. You will be again prompted to enter a password,enter the System Administrator's password (Default = 0000)

5. You will be prompted with "System Administration Menu" and a list of functions you can perform. It will not

be spoken, but you can enter a hidden option [4] to shut down the system.

6. Again you will be asked to enter a password, enter the System Administrator's password (Default = 0000)

7. The system will now shutdown to a C:> DOS Prompt. The Run LED will turn from RED to GREEN. Green means

it is safe to power down the switch.

SVMi-8E/SVMi-16E Set Up with iDCS Phone Systems

Home Page

Table of Contents