Operation Manual

English

Other Information

Issues Solutions and Explanations

The PIP menu is not available. • PIP functionality is only available when you are using a HDMI source.

You turned the LED display off 45 minutes

ago, and it turned on again.

• It is normal. The LED display operates the OTA (Over The Aerial) function itself to upgrade ﬁrmware

downloaded whilst your watching LED display.

The message “Scramble signal” or “Weak

Signal/No Signal” appears.

• If you are using a CAM CARD (CI/CI+), check that it is installed into the common interface slot.

• If there is still a problem, pull the CAM CARD out of the LED display and insert it into the slot again.

There are recurrent picture/sound issues. • Check and change the signal/source.

A reaction may occur between the rubber

cushion pads on the base stand and the

top ﬁnish of some furniture.

• To prevent this, use felt pads on any surface of the LED display that comes in direct contact with

furniture.

✎

This panel uses a panel consisting of sub pixels which require sophisticated technology to produce. However, there may be a

few bright or dark pixels on the screen. These pixels will have no impact on the performance of the product.

¦ Storage and Maintenance

✎

If you attched some stickers on the LED display screen, it remains some debris after removing the sticker. Please clean it to

watch LED display.

✎

The exterior and screen of the product can get scratched during cleaning. Be sure to wipe the exterior and screen carefully

using the cloth provided or a soft cloth to prevent scratches.

Do not spray water or a cleaning agent directly onto the product.

Any liquid that goes into the product may cause a failure, ﬁre, or

electric shock.

Clean the product with a soft cloth dapped in a small amount of

water.

[

CAUTION

If the height of "

" on one side is different from the other side,

adjust the heights.