manual do usuário

15
English
Connections
Connecting to an Antenna
When the TV is initially powered on, basic settings proceed automatically.
✎ Connecting the power cord and antenna.
Plug & Play (Initial Setup)
When the TV is initially powered on, a sequence of on-screen prompts will assist in configuring basic settings. Press the
POWER P button. Plug & Play is available only when the Input Source is set to TV.
✎ To return to the previous step, press the Red button.
1
Selecting a language
Press the ▲ or ▼ button, then press the ENTER
E button. Select
the desired OSD (On Screen Display) language.
P
POWER
INFO GUIDE
2
Selecting Store Demo
or Home Use
Press the ◄ or ► button, then press the ENTER
E button.
y Select the Home Use mode. Store Demo mode is for retail
environments.
y To return the unit’s settings from Store Demo to Home Use
(standard): Press the volume button on the TV. When you see
the volume OSD, press and hold MENU for 5 sec.
y Store Demo is only for shop display. If you select it, several
functions are not able to use. Please select Home Use when
you watch at home.
3
Setting the Clock
Mode
Set the Clock Mode automatically or manually.
y Auto: Allows you to select time zone.
y Manual: Allows you to manually set the current date and time (p. 28).
4
Selecting an antenna
Press the ▲ or ▼ button, then press the ENTER E button.
y If the antenna is connected to ANT 1 IN (AIR), select Air and if it is connected to ANT 2
IN (CABLE), select Cable.
y If both ANT 1 IN (AIR) and ANT 2 IN (CABLE) are connected, select Air+Cable.
5
Selecting a channel After selecting the antenna source to memorize, select Search. The TV will begin
memorizing all of the available channels. For more information, refer to Channel → Auto
Program (p. 24).
y Press the ENTER
E button at any time to interrupt the memorization process.
6
Enjoy your TV.
Press the ENTER
E button.
If You Want to Reset This Feature...
O MENU m → System → Plug & Play → ENTER E
You should do Plug & Play again at home although you did in shop.
✎ If you forget the PIN code, press the remote control buttons in the following sequence in Standby mode, which resets
the PIN to “0-0-0-0”: POWER (off) → MUTE → 8 → 2 → 4 → POWER (on).
Connections
ANT OUT
VHF/UHF Antenna
Cable
or