User Manual

16 17
Satellite System
Screen Menu > Broadcasting > Channel Settings > Satellite System
Try Now
A set of satellite dish settings must be configured for each wanted satellite before performing a
channel scan.
Satellite System is available when Aerial is set to Satellite.
"
The PIN input screen appears. Enter your 4 digit PIN number.
●
Satellite Selection: You can choose the satellites for this TV.
Try Now
●
LNB Power: Enables or disables the power supply for the LNB.
Try Now
●
LNB Settings: Configures the outdoor equipment.
Try Now
Satellite: Selects the satellite for receiving digital broadcasts.
Transponder: Selects a transponder from the list or adds a new transponder.
DiSEqC Mode: Selects DiSEqC mode for the selected LNB.
Lower LNB Oscillators: Sets the LNB oscillators to a lower frequency.
Upper LNB Oscillators: Sets the LNB oscillators to a higher frequency.
Tone 22 kHz: Selects the Tone 22 kHz depending on the LNB type. For a universal LNB it should
be Auto.
●
SatCR/Unicable Settings: Configure single cable installation.
Try Now
"
SatCR is short for satellite channel router.
"
This function may not support depending on the country.
SatCR/Unicable: Enables or disable single cable installation support.
Slot Number: Select the SatCR user slot number for this receiver.
Slot Frequency: Enter the appropriate frequency to receive the signal from SatCR.
Detect Slot Frequency: Auto-detect the signal frequency for the selected slot number.
Verify Slot Frequency: Verify that the frequency entered corresponds to the selected slot.