User Manual
Table Of Contents
- WA54R7200A_DC68-04037C-01_EN
- WA54R7200A_DC68-04037C-01_MES
- Información sobre seguridad
- Lo que necesita saber sobre las instrucciones de seguridad
- Símbolos de seguridad importantes
- Precauciones de seguridad importantes
- PROPOSICIÓN 65 DE CALIFORNIA: ADVERTENCIA
- Advertencias fundamentales para la instalación
- Precauciones para la instalación
- Advertencias fundamentales para el uso
- Precauciones de uso
- Advertencias fundamentales para la limpieza
- Instalación
- Antes de comenzar
- Funcionamiento
- Mantenimiento
- Solución de problemas
- Especificaciones
- Información sobre seguridad
English 51
Troubleshooting
Problem Action
Stops.
• Make sure the washer's power cord is fully plugged in and
the circuit is live.
• Check the fuse or reset the circuit breaker.
• Close the door, and then press or tap Start/Pause (Hold to
Start) to start the washing machine. For your safety, the
washing machine will not spin unless the door is closed.
• Before the washing machine starts to ll, it will make a
series of clicking noises to check the door lock, and then
does a quick drain.
• There may be a pause or soak period in the cycle. Wait
briey and the washing machine may start.
• Make sure the inlet hose lters at the taps are not clogged.
Periodically clean the lters. See page 47.
• This problem can occur temporarily due to low voltage in
your household electrical system. It will be resolved when
the voltage returns to normal.
Fills with the wrong
temperature water.
• Fully open both water taps.
• Make sure the temperature selection is correct.
• Make sure the hoses are connected to the correct water
taps. Flush the water lines.
• Disconnect the hoses and clean the mesh lters. The water
inlet mesh lters may be clogged. See page 46.
• While the washing machine lls, the water temperature
may change as the automatic temperature control feature
checks incoming water temperature. This is normal.
• While the washing machine lls, you may notice just hot
and/or just cold water going through the dispenser when
cold or warm temperatures are selected. This is a normal
function of the automatic temperature control feature as
the washing machine determines the water temperature.
Door (Lid) locked or will
not open.
• While the washing machine is operating, press or tap
Start/Pause (Hold to Start) to stop the washing machine.
• It may take a few moments for the door lock mechanism to
disengage.
Untitled-22 51 2019-02-12 4:50:30