User Manual

12
ENG
When the television is initially powered on, three basic customer
settings proceed automatically and subsequently: setting the
language, channel and clock.
1 If the television is in Standby mode, press the POWER () button
on the remote control.
Result
: The message Plug & Play is displayed. It flickers for
a little while and then
Language menu is automatically
displayed.
2 Select the appropriate language by pressing the ▲ or ▼ button.
Press the
MENU button to enter the language.
Result
: The message Ant. Input : Check is displayed.
➣
If any language is not selected on the Language menu, the
Language menu will disappear about 30 seconds later.
3 Make sure that the antenna is connected to the TV. Press the - or
+ button.
Result
: The
Auto store menu is displayed with Country is
selected.
4 Select your country by pressing the - or + button. To search the
channels, select
Search by pressing the ▲ or ▼ button, and then
press the
- or + button. Press the MENU button to stop the
search.
Result
: The
Time menu is displayed with Clock is selected.
➣
Refer to “Storing Channels Automatically” on page 14.
5 Press the - or + button to move to the hour or minute. Set the
hour or minute by pressing the
▲ or ▼ button.
➣
Refer to “Setting and Displaying the Current Time” on page
30.
6 When you have finished, press the MENU button.
Result
: The message ENJOY YOUR WATCHING is displayed,
and then the channel which has been stored will be
activated.
7 If you want to reset this feature...
1 Press the MENU button.
2 Press the ▲ or ▼ button to select Setup, and then press the -
or + button.
Result
: The Plug & Play is selected.
3 Press the - or + button again.
Result
: This feature starts with the message
Plug & Play
is displayed.
Plug & Play Feature
Plug & Play
ENJOY YOUR WATCHING
Setup
Plug & Play
√√
Language
√√
Blue screen : On
Demonstration
√√
Tilt : 0
TV
Auto store
Country : Others
Search : -/+
TV
Time
Clock : -- : --
Timer : Off
TV
Ant. Input : Check