WSP200 Manual(1J1513 ) 6/10/99 2:04 PM Page 1 Radio Frequency Wireless Speakers w i t h 9 0 0 M H z Tr a n s m i t t e r Freedom From Wires listen anywhere in your home WSP200 900 MHz
WSP200 Manual(1J1513 ) 6/10/99 2:04 PM Page 2 INTRODUCTION Congratulations on the purchase of your new WSP200 Wireless Stereo Speaker System. This System uses the latest 900 MHz High Frequency Radio Signal that can easily travel through walls, floors, ceilings or partitions to allow the finest stereo sound reproduction. You can use your Speakers almost anywhere in and around your home or, for outdoor activities, just place them in the location of your choice.
WSP200 Manual(1J1513 ) 6/10/99 2:04 PM Page 3 CONTROL LOCATIONS TRANSMITTER 1) LED Indicator (Power ON) 2) Power OFF Switch and Channel Selector 3) AUDIO IN Jack (L) - Connect to Music Source 4) AUDIO IN Jack (R) - Connect to Music Source 5) DC Input Jack 2 1 5 4 3 SPEAKER 6) 7) 8) 9) 10) 11) Frequency Channel Selector Tone Control Knob Power OFF and Volume Control Knob DC Input Jack MODE Switch (To Select Left/Mono or Right Channel) Battery Compartment 9 DC IN WS-91 6 ER SYSTEM SS SPEAK WIRELE T
WSP200 Manual(1J1513 ) 6/10/99 2:04 PM Page 4 INSTALLING THE TRANSMITTER You need to properly set up the Transmitter to send a wireless signal to the Speakers. There are two things you must do. First, provide power to the Transmitter, and second, connect the Transmitter to the Audio Source. 1) CONNECTING POWER (A) DC OPERATION Your Transmitter is supplied with a Battery Tray. Insert four (4) x AA Alkaline batteries (not supplied) to the battery slot as indicated.
WSP200 Manual(1J1513 ) 6/10/99 2:04 PM Page 5 INSTALLING A SPEAKER CONNECTING POWER (A) DC OPERATION (with optional BP200SP Battery Pack sold on page 11) • Open the battery cover located at the back of the Speaker unit. Insert the battery making sure the side with the contacts (located on the top edge) is inserted to make contact with the coil springs inside the compartment. Push the battery all the way in until you feel resistance from the coil springs inside the compartment.
WSP200 Manual(1J1513 ) 6/10/99 2:04 PM Page 6 OPERATION Follow these steps to obtain maximum listening performance 1) Make sure that your Transmitter and Speakers are set up according to the procedures given in this manual. 2) Turn on your Audio Source. 3) Switch the Transmitter to a Frequency Channel (Channel 1, 2, or 3) that has no interference. Refer to CHANNEL SELECT below for Precision Frequency Lock-In Tuning.
WSP200 Manual(1J1513 ) 6/10/99 2:04 PM Page 7 BATTERY OPERATION TRANSMITTER When the Transmitter is operated by fresh Alkaline batteries (four (4) AA cellsnot included) the Transmitter will play for approximately 4-6 hours continuously. Once the battery power begins to decrease, you will hear static sound from the Speakers. This indicates that you have to replace the batteries.
WSP200 Manual(1J1513 ) 6/10/99 2:04 PM Page 8 TROUBLESHOOTING If you follow all the instructions in this manual, you should have no problems with your WSP200 Wireless Speaker System. However, in case you can not make the system work, please read the TROUBLESHOOTING section carefully. Do not return to your dealer immediately! Check and follow these guides - you probably can resolve your problems without much difficulty.
WSP200 Manual(1J1513 ) 6/10/99 2:04 PM Page 9 SPECIFICATIONS TRANSMITTER Operating Frequency 912 - 914MHz Channel 1: 911.950 MHz Channel 2: 912.925 MHz Channel 3: 913.900 MHz Power Sources a) AC Adapter (AC 120/60 Hz~DC 6V 600mA) Supplied b) DC four (4) x AA 6V Alkaline Batteries (Not Included) Transmitter Dimensions 6" (H) x 3 1/4" (W) x 4 3/8" (D) RECEIVER SPEAKER(S) Output Power 16 Watts RMS (8 Watts per Channel) Receiving Frequency 911.9 - 9.13.
WSP200 Manual(1J1513 ) 6/10/99 2:04 PM Page 10 RCA ACCESSORIES The following RCA accessories are available through your RCA dealer or: ORDER BY PHONE: Have your Visa, MasterCard or Discover Card ready and call the toll-free number listed below. This number should only be used to place orders.
WSP200 Manual(1J1513 ) 6/10/99 2:04 PM Page 11 BP200SP OPTIONAL BATTERY PACK The BP200SP Battery Pack allows up to 10 hours of continuous play without the need for AC Power. Great for using your Speakers in your yard or on your balcony or patio - where AC power may not be readily available. Features Include: - May be charged hundreds of times - 12V, 4.
WSP200 Manual(1J1513 ) 6/10/99 2:04 PM Page 12 ONE YEAR LIMITED WARRANTY Thomson Consumer Electronics, Inc. warrants that for one year from the date of purchase this product is free from defects in material and workmanship. If the item is defective within that period, return it at your expense to the dealer from whom it was purchased together with proof of purchase for replacement. The exchange unit is under warranty for the remainder of the original product’s warranty period.