User Manual

setup screen
32_ setup screen
6. Click <Port>.
7. Type in each item in the Port menu as necessary.
`
Neither the port range between 0 and 1023 nor port 3702 is available.
• HTTP : HTTP port used to access the camera via the web
browser.
The default is 80(TCP).
`
Setting the HTTP port for Safari and Google Chrome browsers to
65535 is not allowed by security policy.
• HTTPS : In this version, the security of the web communication protocol HTTP is strengthened. It can
be used when you set HTTPS mode in SSL.
The initial value is set to 443(TCP).
`
The available setting range is 1024~65535. (For security reasons, in your Safari or Google Chrome browser, you may not use
65535 as your HTTPS port.)
• RTSP : Used to transfer videos in the RTSP mode; the default is 554.
• Timeout : When connecting to RTSP, this function resets the connection if there’s no response for a
certain time.
M
`
If changed the HTTP port, the browser exits.
Afterwards, address should contain the newly assigned HTTP port trailing the IP.
ex) IP address: 192.168.1.100, HTTP port : Assigned 8080

http://192.168.1.100:8080
(If HTTP port is set to 80, no need to specify the port number)
`
Using RTSP and HTTPS is recommended in order to prevent the image information from being restored.
8. When done, click [Apply].
PTZ SETUP
External PTZ
Configure the connection settings to the external pan/tilt receiver so that you can control the PTZ operations
via the receiver connected to the RS-485 port of the camera.
J
`
In <Video profile>, the external PTZ setup is only available when the PTZ mode is set to <ExternalPTZ>. (page 28)
1. From the Setup menu, select the <PTZ (
)> tab.
2. Click <External PTZ>.
3. Specify the serial port.
You can set the RS-485 communication mode for pan/tilt-
compliant receiver that is connected to the network camera.
• Protocol : From SAMSUNG-T/SAMSUNG-E/PELCO-D/
PELCO-P/SUNGJIN/PANASONIC/HONEYWELL/AD/
VICON/GE/BOSCH, select the same protocol as that of
the receiver.
• Camera ID : Displays the fixed camera ID.
• Baudrate : Transfer rate for RS-485 communications.
• Data bit : Specify the data bit.
• Parity bit : Specify the parity bit.
• Stop bit : Specify the stop bit.
• ONVIF Focus move : Set external camera’s focus for ONVIF controls.
4. When done, click [Apply].
M
`
All these operations above mentioned will be enabled only if the network camera is properly connected to the pan/tilt-
compliant receiver. And the serial port for the pan/tilt operations should be properly specified.
J
`
Check the functions supported by the receiver when it is connected.
Some functions may be disabled depending on the receiver or protocol specification. Refer to the following table for more
details.
Functions Supported for Each Protocol
Protocol
P
control
P
movement
speed
T
control
T
movement
speed
Zoom
control
Zoom
movement
speed
Focus
control
Focus
control
speed
Preset
save
Preset
movement
Remarks
SAMSUNG-T O O O O O O O X O O
SAMSUNG-E O O O O O O O X O O
PELCO-D O O O O O O O X O O
PELCO-P O O O O O O O X O O
SUNGJIN O X O X X X X X O X
PT direction
(Up, down, left,
bottom)