User Manual

English _47
●● SETUP SCREEN
Time schedule
You can configure settings to transmit images at regular intervals at a scheduled operation time regardless of
the occurrence of an event.
1. From the Setup menu, select the <Event (
)> tab.
2. Click <Time schedule>.
3. Set whether or not to <Enable>.
4. Specify the <Transfer interval>.
5. Specify the <Event activation time>.
• Always : Always activates in operated mode at the set
interval.
• Only scheduled time : Periodically activates in operated mode at a specified time and date.
J
`
The transfer interval setting value must be smaller than the preset activation interval to succeed in image transmission.
6. Specify the activation conditions.
• FTP : Specify the use of the FTP transfer if an event occurs.
`
Refer to “FTP / E-mail” for more details. (page 43)
7. When done, click [Apply].
Alarm input
You can set the alarm input type, activation time, and operation mode.
1. From the Setup menu, select the <Event (
)> tab.
2. Click <Alarm input>.
3. Set whether or not to <Enable>.
4. Select the type.
• N.O. (Normal Open) : It is normally open, but if it is closed,
an alarm will be triggered.
• N.C. (Normal Close) : It is normally closed, but if it is open,
an alarm will be triggered.
5. Specify the <Event activation time>.
• Always : Always check if an alarm occurs. It activates in
operated mode when the alarm occurs.
`
If set to <Always>, the activation time cannot be changed.
• Only scheduled time : Check if an alarm occurs at a specified day of the week for a specified time
period. It activates in operated mode when the alarm occurs.
- [
] : Sets the time display format on the vertical axis.
- [Reset] : Reset all settings.
6. Specify an operation that will perform if an alarm occurs.
• FTP : Specify the use of FTP transfer in the alarm input setup.
`
Refer to “FTP / E-mail” for more details. (page 43)
• E-mail : Specify the use of email transfer in the alarm input setup.
`
Refer to “FTP / E-mail” for more details. (page 43)
• Record : You can set up the alarm to record to a Micro SD card or an NAS when operating.
`
Set <Device> to <On> in <Storage>. (page 44)
• Alarm output1 : Select whether to set the alarm output if an alarm is incoming, and specify the alarm
output time.
• Goto preset : Moves to the specified preset location when setting the alarm input.
`
Only if the camera pan/tilt receiver is installed, Goto preset is available.
7. When done, click [Apply].