User Manual

overview
8_ overview
AT A GLANCE
Front Side
Item Description
a
Mounting Bracket Screw
Hole
Used to fix the camera on a mounting bracket.
`
The screw size : It is the specification for the screws used to fasten the camera to the
support.
1/4” -20 UNC
L: 4.5mm±0.2mm (ISO Standard), or 0.197” (ASA Standard)
b
Auto Iris Lens (Optional)
Installed on the lens adaptor.
c
Auto Iris Lens Connector
Used to supply power and output signal to control the iris of the lens.
M
`
Mounting Bracket is not included.
For more information to use mounting bracket, refer to the product’s documentation.
Rear Side
Item Description
a
Reset Button
The button restores all camera settings to the factory default.
Press and hold for about 5 seconds to reboot the system.
J
If you reset the camera, the network settings will be adjusted so that DHCP can be
enabled. If there is no DHCP server in the network, you must run the IP Installer
program to change the basic network settings such as IP address, Subnet mask,
Gateway, etc., before you can connect to the network.
b
Micro SD Memory Card
Compartment
Compartment for the Micro SD memory card.
c
Audio terminal
AUDIO OUT Used to connect to speakers.
AUDIO IN Used to connect to a microphone.
d
MICRO USB port
Port to connect the Wi-Fi dongle.
You can check the installation video through the applications installed in the smartphone.
Refer to “Connect to WiFi dongle” on page 12.
`
Wifi dongle and OTG gender are sold separately.
e
Test Monitor Out
Output port for test monitoring the video output. Use the test monitor cable to connect to a
mobile display and check the test video.
f
Power Port Used to plug the power cable.
g
Network Port Used to connect the PoE or Ethernet cable for network connection.
a
b
c
AUDIO
OUT
MICRO
USB
VIDEO
NETWORK
ACT LINK
DC 12V
AC 24V
FOCUS
1 2 3 4 5 6
RESET
ALARM IN : 1
ALARM OUT : 2
GND:3 NC : 4
RS-485+ : 5
RS-485- : 6
PWR
IN
b ca
f
g
h
j
d
i
e