User's Manual

Voice recording
To record your voice as file to your player. Follow these steps:
1. Press the Power/Menu Button once. The SanDisk logo and Sansa logo will briefly
appear onscreen then disappear. (Can’t find the Power/Menu Button on your
player? See The Basic Controls section on page 3.)
WARNING: If the onscreen message says "Locked" and then shuts off, you
need to locate the Hold Button on the left side of your player. Slide that button
left to unlock your device. Then repeat Step 1 above. See The Basic Controls
section on page 3 if you cannot find the Hold Button.
NOTE: If you do not see the Recorder onscreen, briefly press the Power/Menu
Button on the right side of your player. The software Menu will appear. Use the
Repeat/AB/Down Button to scroll and highlight Modes. Press the Select Button to
select Modes. Press the Play/Pause/Up Button to scroll then highlight the Recorder
mode. Press the Select Button to enter Recorder mode.
2. Press the Power/Menu Button briefly to access the software Menu then use the
Modes setting to switch to Recorder.
3. Press the Play/Pause/Up Button to start recording.
4. During the recording, If the Play/Pause/Down Button is pressed, the recording will
be paused. If the Play/Pause/Down Button is pressed again, the recording will
resume.
5. To stop recording:
 Press the Repeat/AB/Down Button.
6. Saving your recording:
 Once the recording has been stopped you’ll be presented with a message
asking you if you’d like to save the recording. Use the Next/Fast Forward and
Previous/Fast Reverse buttons to move the highlight between the X and check
boxes. To save the recording, press Select with the check box highlighted. To
return to the recorder without saving, press Select with the X box highlighted.
You can play back your saved recordings under the Play Music menu.
Quick Start ` 8