Specifications

9
Observe safety precautions - see chapter" Safety Precautions".
Slide the stop switch (1) to ON
If the engine is cold, turn the choke knob to
If the engine is warm, turn the choke lever to
Also use this position is the engine has been running
but is still cold.
Move the setting lever (2) to the center position - this is the starting throttle position
The setting lever can be used to select any throttle opening between idle speed (lower stop) and full
throttle (upper stop).
Set the lever to idle position before switching off the engine.
Note:
Before starting
Put the unit on the ground. Check that bystanders
are well clear of the general work area and the
nozzle.
Pull the satarter grip slowly with your right hand
until you feel it engage and give it a brisk strong
pull. Do not pull the starter rope out all the way
as it might otherwise break.
Do not let the starter grip snap back.
Make sure you have a firm footing: Hold the unit
with your left hand on the housing and put one
foot againstthe base plate to prevent it slipping.