Specifications

Remove the spring clip (3).
Remove the rope rotor with washer (4) and pawl (5).
Ea
se the cap (6) out of the starter grip.
Remove remaining rope from the rotor and grip.
Tie a simple overhand knot in the end of the new starter rope (see Specifications) and then thread the
r
ope through the top of the grip and the rope bush (7).
Re
fit the cap in the grip.
Thread the rope through the rotor and secure it in the rotor with a simple overhand knot.
Fit the pawl (5) in the rotor and slip the washer (4) over the starter post.
Use a screwdriver or suitable pliers to install the spring clip (3) on starter post and over the peg on the ]
pawl-the spring clip must point clock wise - see illustration.
Go to "Tensioning rewind spring".
Lubricate the new spring with a few drops of non-resinous oil.
Remove the rope rotor as described in "Replacing the starter rope".
Remove parts of old spring.
Fit new spring housing - b
ottom plate must face downward. Engage outer spring loop over the lug.
R
efit the rope rotor.
Go
to "Tensioning rewind spring".
lf the spring pops out and uncoils during installation: Refit it in the spring housing in the counter-
clockwise direction - start outside and work inward.
R
eplacing a broken rewind spring
5
4
3
Make a loop in the unwound starter rope and use it to turn the rope rotor six full revolutions in the
direction of the arrow (see illustration).
Tensioning rewind spring
15