Specifications

Make a loop in the unwound starter rope and use it to turn
the rope rotor six full revolutions in the direction of the arrow
(see illustration).
Hold the rotor steady -.
straighten the twisted rope.
R
elease the rotor and let go of rope slowly so that it winds
onto the rotor.
Th
e starter grip must sit firmly in the rope guide bush. lf the
grip droops to one side: lncrease spring tension by one
additional turn.
When the starter rope is fully extended it must be possible to
rotate the rotor at least another half turn. lf this is not possible,
the spring is overtensioned and could break. Ta
ke one turn of
t
he rope off the rotor.
For periods of about 3 months or longer
Storing the Machine
Fit the starter cover on the enging.
Tighten down the screws firmly.
Mo
ve the stop switch to OFF
Drain and clean the fuel tank in a well ventilated area.
Drain and clean the container.
Ru
n engine until carburetor is dry - this helps prevent carburetor diaphragms sticking together.
Th
oroughly clean the machine- pay special attention to the cylinder fins and air filter.
St
ore the machine in a dry, high or locked location - out of the reach of children and other unauthorized
persons.
Do not expose the container to direct sunlight for unnecessarily long periods. UV rays can make the
container material brittle, which could result in leaks or breakage.
Maintenance Chart
The following maintenance intervals apply to normal operating conditions only.
lf your daily working time is longer than normal or operating conditions are
difficult (very dusty work area etc.), shorten the specified intervals accordingly.
Co
mplete machine
Vi
sual inspection (conditon, leaks)
C
lean
Check operation
Clean
Replace
Check
Replace
Clean
Check idle setting
Readjust idle
Readjust electrode gap
Clean
Check
Clean or replace
Ti
ghten
V
isual inspection (condition, leaks)
C
heck
Visual inspection
H
ave replaced by dealer
x
x
x
x
x x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x x
x
C
o
ntrol handle
Air filter
Filter in fuel tank
fuel tank
Carburetor
Spark plug
Cooling air intakes
Spark arresting screen in muffler
All accessible screws and nuts
(not adjusting screws)
Container with hose
Metering unit
Anti-vibration elements
before starting work after finishing work or daily after each refueling stop weekly monthly every 12 months if problem if damaged if required
16