Use and Care Guide

Table Of Contents

Use as directed. To ensure proper performance, please be sure to contact us if you have installation or operation questions.

Re-Insert Tray

back side of the plastic bottom panel) to ensure it does not have any rips or tears that could cause a

leak from your system.

Also, be sure to replace soil collecting Tray for next time. This is very important!

6. Re-Attach Bottom

Panel

With the 2 inner Knobs still attached, but loose, push with your thumbs on the Knobs to bring the

plastic Bottom Panel until it comes flush with the Knobs.

Place the metal Back Plate downward through the opening in the System. Be sure that the “L” edge

of the metal Back Plate is on the top and the “C” edge is on the bottom. These edges point towards

you when they are on correctly.

Line up the panel evenly and turn the 2 inner Knobs clockwise to tighten. Before completely

tightening the inner Knobs, insert the 2 outer Knobs and turn clockwise to tighten.

Tighten all 4 Knobs. Make sure they are firmly attached. Do not over-tighten.

Check to make sure Bottom Panel is completely attached and that there are no air or liquid gaps. It

should attach evenly with no obvious gaps or uneven parts.

7. Read to Go!

Your Envirolet®/SG System is now ready to use again!

Refer to Start-Up and Operation section for more information about re-starting your system.