ELM205 Power Conditioner (6901-002060 <00>) Sanus Systems 2221 Hwy 36 West Saint Paul, MN 55113 USA Customer Service Americas: 800-359-5520 • 651-484-7988 • info@sanus.com Europe, Middle East, and Africa: + 31 40 2324700 • europe.sanus@milestone.com Asia Pacific: 86 755 8996 9226 • sanus.ap@milestone.com sanus.com ©2010 Milestone AV Technologies, a Duchossois Group Company. All rights reserved. Sanus is a division of Milestone.
A English Español IMPORTANT SAFETY INSTRUCTIONS – SAVE THESE INSTRUCTIONS – PLEASE READ ENTIRE MANUAL BEFORE USING THIS PRODUCT ELM205 Specifications: 2,700 joule surge suppression Dual Stage EMI/RFI noise filtration 20-50dB (100KHz-1MHz) Gold-plated coaxial input and outputs Combo ethernet/phone jack - supports up to 100Base-T connection speeds 125V/60Hz/12 A max Suppressed voltage rating: L-N 400V L-G 500V N-G 500V Audible alarm if surge has served it’s useful life Resettable fuse Inte
B OPT English Tools required CAUTION / WARNING Troubleshooting and Maintenance Optional ATTENTION/ AVERTISSEMENT Dépannage et maintenance Optionnel PRECAUCIÓN/ ADVERTENCIA Resolución de problemas y mantenimiento Opcional Français Outils nécessaires Español Herramientas necesarias 6901-002060 <00> 3
C CAUTION: English Español CAUTION: Avoid potential personal injuries and property damage! The input plug of this power tap is intended to serve as the disconnect device, it shall be easily accessible and withdrawn. Cable distribution system should be grounded (earthed) in accordance with ANSI/NFPA 70, the National Electrical Code (NEC), in particular Section 820.93, Grounding of Outer Conductive Shield of a Coaxial Cable. Do not disassemble the surge protector.
D English Español Supplied Parts and Hardware Before starting assembly, verify all parts are included and undamaged. If any parts are missing or damaged, do not return the damaged item to your dealer; contact Sanus Systems Customer Service. Never use damaged parts! NOTE: Not all hardware included will be used. Piezas y materiales suministrados Antes de iniciar el montaje, verifique que estén incluidas todas las piezas y que ninguna de ellas esté dañada.
English A ELM205 FEATURES A. The Power, Surge, and Ground LED lights illuminate to indicate that the surge protector is working. If the lights fail to illuminate, see Troubleshooting your Power Conditioner on the next page. B. From wall, DSS, cable, or other coaxial output C. To TV, VCR, or other coaxial input Power In Out In Surge Ground Out D. To phone/modem or ethernet input E. From wall outlet or router F. Resettable Fuse B D G. Interchangeable Power Cord H.
Troubleshooting English Español The Power, Surge, and Ground LED lights illuminate under normal operating conditions. If any of the lights fail to illuminate, follow the instructions below. If any of the lights still fail to illuminate, you need to replace your Power Conditioner. Power If the Power light is off, verify that your power conditioner is plugged into a working outlet.
OPT English Español Changing your Power Cord NOTE: 1’ power cord is intended for use in special installations only; such as, dedicated equipment intended to be mounted near a receptacle. 6’ power cord is intended for use in all other installations. Cómo cambiar el cable de alimentación NOTA: El cable de 0,30 m (1 pie) se utiliza en instalaciones especiales solamente, como equipos especializados instalados cerca de un enchufe. El cable de 1,83 m (6 pies) se utiliza para el resto de las instalaciones.
OPT English Español Installing ClickFit NOTE: You should use the ClickFit brackets (X) that are included with select Sanus mounts and the hardware, [03] and [04], that is included with the ELM205. Instalación de soportes ClickFit OPCIONAL NOTA: Debe utilizar los soportes ClickFit (X) que se incluyen con algunos soportes Sanus, y los accesorios, [03] y [04], provistos con el ELM205.
English Español Milestone AV Technologies and its affiliated corporations and subsidiaries (collectively, “Milestone”), intend to make this manual accurate and complete. However, Milestone makes no claim that the information contained herein covers all details, conditions, or variations. Nor does it provide for every possible contingency in connection with the installation or use of this product. The information contained in this document is subject to change without notice or obligation of any kind.