GET IT RIGHT THE FIRST TIME BMF320 INSTRUCTION MANUAL Texto en español, página 13 Follow this step-by-step instruction manual to speed up your installation. WE’RE HERE TO HELP Want to watch a video that shows how easy this DIY project will be? Watch it now at: SANUS.com/2782 Get it right the first time. HeightFinder™ shows you where to drill. Check it out at: SANUS.com/1172 Our US-based install experts are standing by to help. Call us at: 800-359-5520 Or, chat at: SANUS.
IMPORTANT SAFETY INSTRUCTIONS – PLEASE READ MANUAL PRIOR TO USE – SAVE THESE INSTRUCTIONS Please read through these instructions completely to be sure you’re comfortable with this easy install process. Check your TV owner’s manual to see if there are any special requirements for mounting your TV. If you do not understand these instructions or have doubts about the safety of the installation, assembly or use of this product, contact Customer Service 1-800-359-5520.
Dimensions 3-D TV INTERFACE 18.03 458.0 3.94 100.0 15.75 400.0 3.94 100.0 16.40 416.6 0.38 9.7 16.28 413.4 WALL PLATE TOP VIEW - EXTENDED 2.59 65.8 0.33 8.4 20.00 508.1 60.00° 13.03 331.0 SIDE VIEW - EXTENDED 5° 11.39 289.3 SIMULATED 49" FLAT SCREEN TV 15° FULLY ASSEMBLED MOUNT TOP VIEW - RETRACTED SIDE VIEW - RETRACTED 2.04 51.8 15.93 404.5a 2.46 62.5 OFFSET BEFORE YOU BEGIN Remove the stand from your TV — if attached.
Supplied Parts and Hardware WARNING: This product contains small items that could be a choking hazard if swallowed. Before starting assembly, verify all parts are included and undamaged. If any parts are missing or damaged, do not return the damaged item to your dealer; contact Customer Service. Never use damaged parts! NOTE: Not all hardware included will be used. STEP 1 Parts and Hardware 01 Washers TV Screws (qty. 4 each) (qty.
1.3 Attach TV Brackets to Your TV 1 2 MEASURE W ADJUST TO WIDTH W M W H M 06 W mm H mm inches cm mm 4 7⅞ 11 ¾ 15 ¾ 10 20 30 40 100 200 300 400 300 mm position illustrated inch dimensions are approximate Measure the WIDTH and HEIGHT of your TV's mounting hole pattern. Adjust mounting tabs M on TV brackets 06 to match the width W of your TV's mounting hole pattern.
4 5 LOOSELY ASSEMBLE CENTER 04 06 06 06 4X A NO SPACER 02 B SPACER NEEDED 01 02 01 03 Adjust TV brackets 06 to align with your TV hole pattern. Install using the screw 01 /washer 02 /spacer 03 combination you selected for your TV. 6 TV bracket 04 must be centered on your TV, but can be offset up or down to avoid cable interference.
STEP 2 Attach Wall Plate to Wall WARNING: This product contains small items that could be a choking hazard if swallowed. Before starting assembly, verify all parts are included and undamaged. If any parts are missing or damaged, do not return the damaged item to your dealer; contact Customer Service. Never use damaged parts! NOTE: Not all hardware included will be used. Parts and Hardware for STEP 2 C Washer Lag Bolt CABLE COVERS (ATTACHED) 1/4 x 2 ¾ in. WALL PLATE COVER 09 x2 1/4 in.
STEP 2A Attach Wall Plate Wood Stud Installation CAUTION: Avoid potential personal injury or property damage! Min. 3 ½ in. (8.9 cm) Min. 1 ½ in. (3.8 cm) ● Drywall covering the wall must not exceed 5/8 in. (1.5 cm) ● Minimum wood stud size: nominal 2 x 4 in. (5.1 x 10.2 cm) actual 1 ½ x 3 ½ in. (3.8 x 8.9 cm) Max. 5/8 in. (1.5 cm) ● Stud center must be verified 1 LOCATE STUD 4 POSITION TEMPLATE Visit HeightFinder™ 2 VERIFY 5 DRILL MARK 6 REMOVE COVERS P sanus.com /1172 2X 2 ¾ in. (7.
Solid Concrete or Concrete Block Installation STEP 2B Attach Wall Plate CAUTION: Avoid potential personal injury or property damage! 1 POSITION TEMPLATE Visit HeightFinder™ sanus.com /1172 ● Mount the arm assembly 06 directly onto the concrete surface (no surface covering) ● Minimum solid concrete thickness: 8 in. (20.3 cm) 05 ● Minimum concrete block size: 8 x 8 x 16 in. (20.3 x 20.3 x 40.6 cm) 2 DRILL 3 in. (7.
STEP 3 Attach TV to Wall Plate WARNING: Before starting assembly, verify this part is undamaged. If damaged, do not return the damaged item to your dealer; contact Customer Service. Never use damaged parts! 1 HANG YOUR TV HEAVY! You may need assistance with this step. NOTE: TV shifts 2.4 in. (6.2 cm) to the right or left when in the home position. Consider this when selecting the location of your wall mount. 04 Parts and Hardware for STEP 3 Hex Key Hex Key 5/32 in. Securement Screw 3/32 in.
Manage Cables 1 2 ROUTE CABLES ATTACH COVERS C C 08 08 C IMPORTANT: Pull arm 08 to its full extension, to leave enough slack and prevent stretching the cables when the arms are moved. C Remove the cable covers C from the arm 08 by sliding to unlock. Route the cables along the arm. Reattach cable covers C to capture the cables.
EXTEND / RETRACT -- ONLY IF NECESSARY E 13 E E 13 13 TIP: CAUTION: Avoid potential personal injury or property damage! DO NOT remove screws E , only turn enough for slight adjustment. ONLY If needed, adjust the arm tension when you extend or retract your TV, with screw E using hex key 13 . REMOVE THE TV HEAVY! You may need assistance with this step. 1 2 12 1. Disconnect all cables from the TV. 2. 3. Remove securement screw 12 . Pull down on the release cord R to release the TV. 4.
ESPAÑOL INSTRUCCIONES IMPORTANTES DE SEGURIDAD – LEA TODO ESTE MANUAL ANTES DE UTILIZAR ESTE PRODUCTO – GUARDE ESTAS INSTRUCCIONES Lea atentamente estas instrucciones en su totalidad para asegurarse de que está familiarizado con el sencillo proceso de instalación. Consulte igualmente el manual de su televisor para conocer si existen requisitos especiales para el montaje de su aparato.
ESPAÑOL 1.1 Seleccione el diámetro de los tornillos para el televisor PÁGINA 4 1.2 Seleccione la longitud de los tornillos y los espaciadores de su TV PÁGINA 4 Solo un tamaño de tornillo es compatible con su TV. A SIN ESPACIADOR • TV con parte posterior plana [los soportes del televisor se apoyan planos sobre su TV] Utilice tornillos de televisor 01 cortos. No es necesario usar 03 espaciadores.
PASO 2B Fijar la placa mural para hormigón sólido o bloques de cemento PÁGINA 9 PRECAUCIÓN: Evite lesiones personales y daños materiales. ESPAÑOL ● Instale la placa mural 08 directamente sobre la superficie de hormigón ● Espesor mínimo del hormigón: 203 mm (8'') ● Tamaño mínimo del bloque de cemento: 203 x 203 x 406 mm (8'' x 8'' x 16'') 1 COLOCAR LA PLANTILLA DE LA PLACA MURAL CONSEJO: Para calcular la ubicación concreta de la placa mural, pruebe nuestra herramienta Height Finder disponible en sanus.
REGISTER YOUR PRODUC T Register your new mount to make the most of your SANUS warranty. Visit SANUS.com to register now– it takes 25 seconds! IT’S TIME TO SHOW OFF When you share your handiwork with your friends, tag #sanusspaces for a chance to be featured on SANUS.com @sanussystems SanusSystems pinterest.com/SANUS SanusSystems 800-359-5520 • info@sanus.com • SANUS.