DVR User Manual

ALARM REC MODE SET8
English 67
z This unit’s motion sensors cannot be used when a
multiplexer is connected. In such a case, please use the
multiplexer’s motion sensors.
z When using the multiplexer’s motion sensors, connect
the alarm output on the multiplexer to this unit’s alarm
input.
z When using a multiplexer, connect its ground terminal
and the recorder's ground terminal.
If a motion sensor is set on the monitor, alarm recording
will be carried out when a moving subject is detected.
1 Move the cursor to “MOTION SENSOR”
and press the [ ] button.
The motion sensor screen is displayed.
2 Press the [ ] or [ ] button to select
sensor operation positions (up to 80),
then press the [ ] or [ ] button to
confirm the selection.
Press the [ ] or [ ] button to turn sensors “ON” (shown
as
J ) and “OFF” (shown as ).
3 Move the cursor to “LEVEL”, then press
the [ ] or [ ] button to change the
setting.
[Settings] ( indicates default setting.)
4 Move the cursor to “EXIT”, then press
the [ ] or [ ] button to return to the
<ALARM REC MODE SET> screen.
5 Press the [EXIT/OSD] button.
The display returns to the normal screen.
 If recording is ended during alarm recording
using the motion sensor
Set the sensitivity from the motion sensor screen to
“OFF”. (See the procedure 3.)
z Pressing the [MENU RESET] button in the motion
sensor screen sets the entire row in which the cursor is
located.
Setting the motion sensor
Motion sensor
screen
Setting
example
Setting Description
OFF Not carried out
1 to 10
Motion sensing will be carried out. Lower values
correspond to higher sensitivities.
e00_l8had_us_7.book Page 67 Wednesday, March 10, 2004 2:47 PM